operators_manual

NOTE
Make sure to reconnect the ground
(negative) cable last.
WARNING
Battery replacement may alter or dis-
turb battery cable routing. Check to in-
sure battery cables are free from any
point of chaffing. Failure to comply
may result in death, personal injury,
equipment or property damage.
1. Place batteries in vehicle and
tighten bolt of holding plate.
2. Reconnect positive cable.
3. Reconnect ground (negative)
ground cable.
Replace Battery Box Cover
Certain parts must be reinstalled when
accessing the under cab battery box.
WARNING
Always reinstall steps before entering
the cab or accessing the deck plate.
Without steps you could slip and fall.
Failure to comply may result in person-
al injury or death.
WARNING
Fairings not installed properly could
come loose and cause other motorists
to have an injury accident. It is impor-
tant that fairings be installed properly.
Failure to comply may result in death,
personal injury, equipment or property
damage.
1. Replace battery cover.
2. Install 2 bolts in step strut. Torque
to 24-32 lb-ft (33-43 Nm).
3. Install fairing and install 4 bolts.
Torque to 6-7 lb-ft (8-9 Nm).
4. Install steps by installing 2 bolts in
each step. Torque to 24-32 lb-ft
(33-43 Nm).
Slow Battery Charging
A slow trickle charge is recommended for
optimum performance from the batteries.
WARNING
Charger cables must be connected
positive to positive (+ to +) and nega-
tive to negative ( - to - ). If connected
improperly, batteries could explode.
Failure to comply may result in death,
personal injury, equipment or property
damage.
WARNING
Always make sure the battery charger
is OFF before connecting or discon-
necting the cable clamps. To reduce
the danger of explosions and resulting
death or personal injury, do not con-
nect or disconnect charger cables
while the charger is operating.
MAINTENANCE - Electrical System
Y53-6047-2HEN (03/18) 235
5