operators_manual

System Component Task I A B C D E
Hub, Drum,
and Hubcap
Hubs (non-LMS) Check the bearing endplay and adjust as
required; see Wheels on page 264.
•
Hubs (non-LMS) with Outrunner Seals Clean the components and check for
excessive wear or damage. Change the
oil and seal; see Wheels on page 264.
•
Hubs (non-LMS) with Standard Seals Clean the components and check for
excessive wear or damage. Change the
oil and seal; see Wheels on page 264.
•
Hub Seals (all) Check for leaks: replace as required. •
LMS Hubs (Dana) Inspect for leaks. Check the bearing
endplay and adjust as required; see
Wheels on page 264.
•
LMS Hubs (Dana) with Synthetic
Lubricant
Service the bearings, seals and oil. This
interval may be different depending on
the results of the regular inspection. See
Wheels on page 264.
500,000 miles/ 800,000 km
LMS Hubs (Dana) with Mineral Lubricant Service the bearings, seals and oil. This
interval may be different depending on
the results of the regular inspection. See
Wheels on page 264.
350,000 miles/ 560,000 km
MAINTENANCE - Maintenance Schedule
Y53-6047-2HEN (03/18) 187
5