operators_manual

Table Of Contents
System Component Task I A B C D E
Drive Axle
(Meritor City
Delivery /
OFF
HIGHWAY)
Axle Housing Check the "cold" fill level at the
differential carrier plug for a pinion angle
of less than 7 degrees, or at the axle
bowl plug for a pinion angle of greater
than 7 degrees. Tighten the plug to 35-50
lb-ft (47-68 Nm)
Visually inspect for damage or leaks.
Drain and replace the lubricant. See Rear Axle Lubrication on
page 257
Lubricant Filter Change the filter
Breather Check the operation. If the cap doesn’t
rotate freely, replace.
Input Shaft and Pinion Shaft Check and adjust the endplay.
Axle Shaft Tighten the rear axle flange nuts to the
specified torque value.
Interaxle Differential Check the operation.
MAINTENANCE - Maintenance Schedule
Y53-6047-2HEN (03/18) 183
5