operators_manual

2. To return to previous beam: pull the
lever towards the steering wheel
again.
The blue indicator light in the instrument
panel will turn ON and the high beams will
turn on.
How to Momentarily Flash High
Beams
The "flash to pass" high beam function is
operated by the same steering column
lever for the turn signals. The high beam
flash to pass will work if the headlights are
not on.
1. Gently push the turn signal lever,
away from the steering wheel.
2. The lever will automatically return
when the lever is released.
The blue indicator light in the instrument
panel will momentarily turn ON and the
high beams will flash. The high beams will
not remain on if the lever is still pressed.
NOTE
The “flash to pass” functionality of the
headlight switch is not available for ve-
hicles manufactured with High Intensi-
ty Discharge (HID) headlamps. Please
check with local regulations regarding
restrictions on using high beam flash-
ing.
NOTE
Continued pressing of the high beam
flash will not keep the high beams on.
How to Flash Marker and Clearance
Lights
A button on the turn stalk will momentarily
flash the marker and clearance lights when
pushed.
1. Push the small button on the end of
the turn stalk
Operate the Windshield Wipers
This vehicle is equipped with a two speed,
intermittent windshield wiper system. The
windshield wiper system is integrated with
the exterior lights so that the low beam
headlights will turn on when the windshield
wipers turn on.
WARNING
Clean blades regularly with a damp
cloth to remove road film and wax
buildup. Do not drive with worn or dirty
wiper blades. They can reduce visibili-
ty, making driving hazardous which
may lead to an injury accident result-
ing in death or personal injury.
CONTROLS - Steering Column Controls
Y53-6047-2HEN (03/18) 105
3