operators_manual

2. PUSH and HOLD the lever down
fully.
3. Push or pull the wheel to the
desired height and angle.
4. PUSH the lever back into the
locked position.
How to Use the Turn Signal
The lever-action turn signal/high beam
switch is located on the left side of the
steering column. Each time a turn indicator
is activated the buzzer emits a short beep.
The ignition key must be turned to ON for
the signal/switch to operate.
NOTE
If the vehicle turn signals and turn sig-
nal indicators in the dash gauge clus-
ter ever begin flashing at an accelerat-
ed rate (115 cycles per minute) when
the turn signal lever is in the OFF
(center) position, or when a Right/Left
turn has been selected, the problem
may be related to a failed turn signal
switch or turn signal module. In either
case, the problem is not a failed bulb.
Contact your nearest authorized deal-
er to have the problem corrected as
soon as possible.
1. Push the lever up to engage the
RIGHT turn signal and down to
engage the LEFT turn signal.
2. Release the signal stalk
3. The turn signal will cancel when
the turn is complete.
Each time the turn indicator is activated the
audible warning emits a short beep.
WARNING
After you complete a turn, shut the
system off by returning the lever to the
"OFF" (center) position. Failure to shut
off a turn signal could confuse other
drivers and result in an injury accident.
An indicator light in the instrument
panel will flash until the turn signal is
turned off.
How to Turn on High Beams
The high beam function is operated by the
same steering column lever for the turn
signals. High beams will not turn on if the
headlights are turned off.
1. Gently pull the turn signal lever,
toward the steering wheel, until you
hear the switch click and the beam
changes.
CONTROLS - Steering Column Controls
104 Y53-6047-2HEN (03/18)
3