operators_manual

Lights, Hazard
This switch operates the emergency
flashers. With the switch in the ON
position, the emergency flasher makes all
four turn signals (front and rear) flash
simultaneously. The flasher works
independently of the ignition switch. You
should always use the flasher if the vehicle
is disabled or parked under emergency
conditions.
WARNING!
Use your Hazard Warning Light System any
time you have to stop off the road or on the
side of the road, day or night. A hard-to-see
vehicle can result in an injury accident. An-
other vehicle could run into you if you do not
set your flashers and follow the placement
of emergency signals per FMCSR 392.22.
Lights, Headlight
Turn switch for park/marker lights and
headlights. When the Headlights are ON,
the dash lights, side, and tail lights are also
on. Headlights will turn on if the windshield
wipers are turned on. Manually turning the
headlights on and then off will override this
function until the next time the vehicle is
turned on.
CAUTION
If you have confirmed there is a problem in
the low beam wiring circuit, proceed with
caution to the next available exit/turnoff and
safely pull your vehicle completely off the
road and call for assistance. Driving your
vehicle with the headlamps on high beam
(at reduced intensity) for a prolonged period
could lead to an injury accident. Contact
your nearest dealer to have the problem
corrected as soon as possible.
Lights, Marker/Clearance
Turn switch on to control Cab and Vehicle
Marker/Clearance lights.
NOTE
An interrupt switch for the trailer marker
lights is mounted on the end of the turn sig-
nal lever.
Lights, Marker/Clearance/Trailer
Turn switch on to control Trailer Marker/
Clearance lights separately from the
vehicle marker/clearance lights.
CONTROLS - Dash Switches
90 Y53-6096-1A1 (01/17)
3