operators_manual

Table Of Contents
NOTE
The “flash to pass” functionality of the head-
light switch is not available for vehicles man-
ufactured with High Intensity Discharge
(HID) headlamps. Please check with local
regulations regarding restrictions on using
high beam flashing.
NOTE
Continued pressing of the high beam flash
will not keep the high beams on.
How to Flash Marker and
Clearance Lights
A button on the turn stalk will momentarily
flash the marker and clearance lights when
pushed.
1. Push the small button on the end of
the turn stalk
Operate the Windshield
Wipers
This vehicle is equipped with a two speed,
intermittent windshield wiper system. The
windshield wiper system is integrated with
the exterior lights so that the low beam
headlights will turn on when the windshield
wipers turn on.
WARNING!
Clean blades regularly with a damp cloth to
remove road film and wax buildup. Do not
drive with worn or dirty wiper blades. They
can reduce visibility, making driving hazard-
ous which may lead to an injury accident re-
sulting in death or personal injury.
CAUTION
Do not use antifreeze or engine coolant in
the windshield washer reservoir, damage to
seals and other components will result.
To override this function, turn the
headlights on and then off again and the
low beams will turn off. Permanently
overriding this functionality is attainable via
the Settings Menu in the instrument cluster
display. Go to Settings - > Wiper Interlock
and turn this value to OFF.
Avoid running the wiper blades over a dry
windshield to prevent scratching the glass.
Spray on washer fluid first. A scratched
windshield will reduce visibility.
A seven-position rotary wiper switch
(located on the turn signal lever) operates
the windshield wipers and washer. If you
need to use the windshield wipers:
1. Rotate the end of the turn signal
lever to change the wiper mode
from off to on.
2. Continue to rotate the outer knob of
the turn stalk lever to adjust the
wiper speed.
4 levels of intermittent speeds
Low wiper speed
High wiper speed
CONTROLS - How to Flash Marker and Clearance Lights
76 Y53-6096-1A1 (01/17)
3