operators_manual

2. Release the signal stalk
3. The turn signal will cancel when the
turn is complete.
Each time the turn indicator is activated the
audible warning emits a short beep.
WARNING!
After you complete a turn, shut the system
off by returning the lever to the "OFF" (cen-
ter) position. Failure to shut off a turn signal
could confuse other drivers and result in an
injury accident. An indicator light in the in-
strument panel will flash until the turn signal
is turned off.
How to Turn on High
Beams
The high beam function is operated by the
same steering column lever for the turn
signals. High beams will not turn on if the
headlights are turned off.
1. Gently pull the turn signal lever,
toward the steering wheel, until you
hear the switch click and the beam
changes.
2. To return to previous beam: pull the
lever towards the steering wheel
again.
The blue indicator light in the instrument
panel will turn ON and the high beams will
turn on.
How to Momentarily Flash
High Beams
The "flash to pass" high beam function is
operated by the same steering column
lever for the turn signals. The high beam
flash to pass will work if the headlights are
not on.
1. Gently push the turn signal lever,
away from the steering wheel.
2. The lever will automatically return
when the lever is released.
The blue indicator light in the instrument
panel will momentarily turn ON and the
high beams will flash. The high beams will
not remain on if the lever is still pressed.
CONTROLS - How to Turn on High Beams
Y53-6096-1A1 (01/17) 75
3