operators_manual

3. Station Selector (for Dual Steer
Applications)
4. Fog Lights
5. Mirror Control
6. Cab Lighting Dimmer Control
7. Differential Lock
8. Differential Lock
9. Lift Axle
10. Lift Axle
11. Lift Axle
Dual Station Switch
The dual station switch allows the controls
for the vehicle from left hand to right hand
operation.
Pushing this switch will engage electronic
switchs on the right hand side of the
vehicle. Certain controls on the left hand
side of the cab cannot be used when right
hand operation is in effect. Vehicle
operation will revert back to the left hand
drive position when the ignition is turned to
the OFF position.
Steering Column Controls
The turn signal lever is mounted on the left
side of the steering column. The lever
controls several functions: turn signal, high
beam, and windshield wiper control.
1. Mulitfunction turn signal/wiper/
washer
2. City Horn
How to Use the Turn
Signal
The lever-action turn signal/high beam
switch is located on the left side of the
steering column. Each time a turn indicator
is activated the buzzer emits a short beep.
The ignition key must be turned to ON for
the signal/switch to operate.
NOTE
If the vehicle turn signals and turn signal in-
dicators in the dash gauge cluster ever be-
gin flashing at an accelerated rate (115 cy-
cles per minute) when the turn signal lever
is in the OFF (center) position, or when a
Right/Left turn has been selected, the prob-
lem may be related to a failed turn signal
switch or turn signal module. In either case,
the problem is not a failed bulb. Contact
your nearest authorized dealer to have the
problem corrected as soon as possible.
1. Push the lever up to engage the
RIGHT turn signal and down to
engage the LEFT turn signal.
CONTROLS - Dual Station Switch
74 Y53-6096-1A1 (01/17)
3