operators_manual

• Illuminates during the power-on self-
test when the ignition is turned ON.
It turns off after a few seconds if no
system problems are detected. If an
ATC problem is detected, the ATC
warning lamp will turn on and stay
on.
• Illuminates when the ATC is
regulating wheel spin and turns off
after the traction control event has
ended.
• Flashes continuously when the
ATC/ Deep Snow & Mud switch is
turned on, indicating that this
feature is active.
WARNING!
If this chassis is equipped with an electronic
stability control (ESC) and is modified (e.g.
adding or removing an axle, converting from
a truck to a tractor, converting from a tractor
to a truck, changing the body, lengthening of
the wheelbase and/or frame, relocating
frame components, or modifying pneumatic
or electrical ABS/ESC harnesses) the ESC
must be disabled by a qualified technician. If
you have any questions, contact your au-
thorized dealer. Failure to comply may result
in death, personal injury, equipment or prop-
erty damage.
NOTE
For more information about the stability con-
trol system installed on your vehicle, please
refer to additional material supplied with this
operator manual, included in your glove box
informational packet.
Axle, Stability Control
Calculates the driver’s intended path of
travel from wheel speed and steering angle
sensors, then compares calculations to the
actual direction of travel. The system uses
individual wheel brakes to re-adjust the
path of the vehicle.
• The Stability Control Icon (ESC or
Electronic Stability Control)
illuminates during the power-on self
test when the ignition is turned ON.
It turns off after a few seconds if no
system problems are detected. If a
problem is detected, the ESC
Warning lamp will turn on and stay
on.
• Illuminates when the ESC system is
regulating individual wheel brakes to
correct the vehicle’s direction of
travel. (Refer to Advanced ABS with
Stability Control for more
information.)
WARNING!
If this chassis is equipped with an electronic
stability control (ESC) and is modified (e.g.
adding or removing an axle, converting from
a truck to a tractor, converting from a tractor
to a truck, changing the body, lengthening of
the wheelbase and/or frame, relocating
frame components, or modifying pneumatic
or electrical ABS/ESC harnesses) the ESC
must be disabled by a qualified technician. If
you have any questions, contact your au-
thorized dealer. Failure to comply may result
in death, personal injury, equipment or prop-
erty damage.
CONTROLS - Guide to the Warning Symbols
58 Y53-6096-1A1 (01/17)
3