operators_manual

Table Of Contents
CAUTION
Do not try to pump the cab down or
hold it down with hydraulic force. If
you do, cab damage will occur.
2. Place the control valve handle in the
"Lower" position. The cab should
settle down on the rear mounts.
3. Allow at least 20 seconds after the
cab touches down for the full spring
force to develop in the latch hooks
in the rear mounts.
4. Remove the pump handle and store
in the cab.
5. Visually inspect the cab latch hooks
to ensure they are closed.
6. Ensure that the control valve handle
is in the “Lower” position when
operating the vehicle.
Standard Seat
WARNING!
Do not adjust the driver's seat while the ve-
hicle is moving. The seat could move sud-
denly and unexpectedly and can cause the
driver to lose control of the vehicle. Make all
adjustments to the seat while the vehicle is
stopped. After adjusting the seat and before
driving off, always check to ensure that the
seat is firmly latched in position. Failure to
comply may result in personal injury, death,
equipment or property damage.
The standard driver's seat can be adjusted
forward and rearward. These movements
are each controlled by levers located on
the FRONT of the seat.
Seat with Air Suspension (Optional)
The driver's seat with air suspension can
be adjusted on the side of the seat for seat
height and backrest incline. The front of the
seat has controls to move the seat fore and
aft.
WARNING!
Before driving or riding in vehicle, ensure
that there is adequate head clearance at
maximum upward travel of seat. Injury may
occur if head clearance is not adequate.
Failure to comply may result in personal in-
jury or death.
Safety Restraint Belts
Important safety information on how to use
seat belts.
Safety belts have proven to be the single
most effective means available for
reducing the potential for either death or
personal injury in motor vehicle accidents.
The combination lap-shoulder belt is
equipped with a locking mechanism. The
system adjusts automatically to a person's
size and movements as long as the pull on
the belt is slow. Hard braking or a collision
locks the belt. The belt will also lock when
SAFETY - Standard Seat
18 Y53-6096-1A1 (01/17)
1