operators_manual

Table Of Contents
Removing Batteries
Information on removing batteries.
After accessing the battery, these steps
can be used to remove them from the
vehicle.
1. Be sure all switches on the vehicle
are turned OFF.
2. Wait 2 minutes after turning ignition
off then disconnect negative ground
cable first.
3. Disconnect positive cable.
4. Unscrew the holding plate bolts with
open end wrench.
NOTE
Always dispose of automotive bat-
teries in a safe and responsible
manner. Contact your authorized
dealer for disposal standards. Call
your local authorized recycling cen-
ter for information on recycling auto-
motive batteries.
Follow the procedures below to reinstall
batteries on the vehicle and replace parts
removed for access.
Installing Batteries
Follow the procedure below to reinstall
main batteries on the vehicle:
NOTE
Always dispose of automotive batteries in a
safe and responsible manner. Contact your
authorized dealer for disposal standards.
Call your local authorized recycling center
for information on recycling automotive bat-
teries.
NOTE
Make sure to reconnect the ground (nega-
tive) cable last.
WARNING!
Battery replacement may alter or disturb
battery cable routing. Check to insure bat-
tery cables are free from any point of chaff-
ing. Failure to comply may result in death,
personal injury, equipment or property dam-
age.
1. Place batteries in vehicle and
tighten bolt of holding plate.
2. Reconnect positive cable.
3. Reconnect ground (negative)
ground cable.
Slow Battery Charging
A slow trickle charge is recommended for
optimum performance from the batteries.
WARNING!
Charger cables must be connected positive
to positive (+ to +) and negative to negative
( - to - ). If connected improperly, batteries
could explode. Failure to comply may result
in death, personal injury, equipment or prop-
erty damage.
WARNING!
Always make sure the battery charger is
OFF before connecting or disconnecting the
cable clamps. To reduce the danger of ex-
plosions and resulting death or personal in-
jury, do not connect or disconnect charger
cables while the charger is operating.
MAINTENANCE - Electrical System
Y53-6096-1A1 (01/17) 185
5