operators_manual

System Component Task I A B C D E
* Use only Spicer Driveshaft approved lubricants when greasing Spicer U-joints. ** Refer to Spicer Driveshaft service manual DSSM-0100 (3264-SPL) for
detailed instructions.
Battery Boxes,
Tool Boxes, and
Steps
Battery Cables Check the condition of the cables, cushion clamps,
nylon tie straps, and routing. Replace a cushion clamp
if the rubber has deteriorated. Repair or tighten
terminals, and secure cables to prevent chafing.
Replace damaged cables (cuts, cracks, or excessive
wear); see Batteries on page 181.
•
Batteries (ON HIGHWAY and LINE HAUL) Check for cracks and damage, electrolyte level,
condition of terminals, and tightness of holddowns; see
Batteries on page 181.
•
Batteries (OFF- HIGHWAY) Check for cracks and damage, electrolyte level,
condition of terminals, and tightness of holddowns; see
Batteries on page 181.
•
Battery Box and Tray (ON HIGHWAY and LINE HAUL) Check the box integrity. Clean the drain tube and check
for acid leaks. Check condition of all equipment
mounted under the box.
•
Battery Box and Tray (OFF-HIGHWAY) Check the box integrity. Clean the drain tube and check
for acid leaks. Check condition of all equipment
mounted under the box.
•
Battery Cable Fasteners Check battery cable fasteners and tighten as
necessary to 10-15 lb-ft (13.6-20.3 Nm) as specified on
the battery label.
•
MAINTENANCE - Maintenance Schedule
148 Y53-6096-1A1 (01/17)
5