operators_manual

System Component Task I A B C D E
Steering
Components
Steering Linkage Check all joints for excessive lash: replace as required;
see Steering System on page 204.
•
Draglink Tube Clamp and Ball Socket Check the torque: tighten to specified torque value as
required.
• •
Pitman Arm Clamp Bolt and Nut Check the torque: tighten to specified torque value as
required.
• •
Steering Intermediate Shaft Check the torque on the pinch bolt and nut. • •
Steering Intermediate Shaft U-joints (ON HIGHWAY) Lubricate [EP NLGI #2 HD grease, +325°F to -10°F
(+163°C to -23°C) range].
• •
Steering Intermediate Shaft U-joints (OFF HIGHWAY
or CITY DELIVERY)
Lubricate [EP NLGI #2 HD grease, +325°F to -10°F
(+163°C to -23°C) range].
• •
Draglink and Tie Rod Arm Ball Sockets (ON
HIGHWAY)
Lubricate (EP NLGI #2 lithium-based, moly-filled, HD
grease).
• •
Draglink and Tie Rod Arm Ball Sockets (OFF
HIGHWAY or CITY DELIVERY)
Lubricate (EP NLGI #2 lithium-based, moly-filled, HD
grease).
• •
Fuel and Tanks Fuel Tanks Inspect tanks, brackets, hoses, and fittings for correct
location, tightness, abrasion damage, and leaks: repair
or replace as required.
•
Fuel Tank Breathers Check for proper function: clean the drain hoses. •
Fuel Tank Straps Check the strap tightness: tighten to proper torque
value as required; aluminum tank - 30 lb-ft (41 Nm)
cylindrical steel tank - 8 lb-ft (11 Nm)
• •
Fuel Tank Steps Check for snug fit of side plates against tank and tank
straps. Check for damaged or broken steps, missing
bolts, and missing grommet between tank and side
plate. Replace missing or damaged parts and adjust for
fit as required.
•
MAINTENANCE - Maintenance Schedule
146 Y53-6096-1A1 (01/17)
5