operators_manual

System Component Task I A B C D E
Clutch Clutch Hydraulic Fluid Replace fluid and bleed system. 240,000 miles/384,000 km or 2 years,
whichever occurs first.
Clutch Release Bearing Lubricate. •
Inspect and adjust when necessary (no adjustment
required for SOLO type clutches)
•
Cooling Hoses Check the radiator and heater hoses for leaks. • •
Extended Life Coolant (ELC) Check the freeze point; see Cooling System
Maintenance on page 168.
•
Check for contamination using test strips; see Cooling
System Maintenance on page 168.
•
Replace blank water filter if applicable. •
Perform lab analysis. If lab analysis shows coolant is
unsuitable for continued use: Flush, drain, and refill.
Add ELC Extender; see Cooling System Maintenance
on page 168.
•
Flush, drain, and refill with new coolant; see Cooling
System Maintenance on page 168.
•
Fan Clutch Check for air leaks. See Engine Fan on page 189.
Check the fan drive bearings (turn the sheave in both
directions to check for worn hub bearings).
• •
Solenoid Valve Check the fan drive for proper engagement and
disengagement.
• •
MAINTENANCE - Maintenance Schedule
Y53-6096-1A1 (01/17) 143
5