operators_manual

Table Of Contents
System Component Task I A B C D E
Drive Axle (Meritor
Line Haul / ON
HIGHWAY)
Axle Housing Check the "cold" fill level at the differential carrier plug
for a pinion angle of less than 7 degrees, or at the axle
bowl plug for a pinion angle of greater than 7 degrees.
Tighten the plug to 35-50 lb-ft (47-68 Nm)
Visually inspect for damage or leaks.
Drain and replace the lubricant See Rear Axle Lubrication on page 203
Lubricant Filter Change the filter
Breather Check the operation. If the cap doesn’t rotate freely,
replace.
Input Shaft and Pinion Shaft Check and adjust the endplay.
Axle Shaft Tighten the rear axle flange nuts to the specified torque
value.
Interaxle Differential Check the operation.
MAINTENANCE - Maintenance Schedule
Y53-6096-1A1 (01/17) 137
5