User Manual

flash with the turn signal activated, even
with the brakes applied.
How to Use the T
urn Signal
The lever-action turn signal/high beam
switch is located on the left side of the
steering column. The ignition key must be
turned to ON for the signal/switch to
operate.
NOTE
If the vehicle turn signals and turn sig-
nal
indicators in the dash gauge clus-
ter ever begin flashing at an accelerat-
ed rate (115 cycles per minute) when
the turn signal lever is in the OFF
(center) position, or when a Right/Left
turn has been selected, the problem
may be related to a failed turn signal
switch or turn signal module. In either
case, the problem is not a failed bulb.
Contact your nearest authorized deal-
er to have the problem corrected as
soon as possible.
1. Push the Signal stalk lever up to
engage the RIGHT turn signal and
down to engage the LEFT turn
signal.
2. Release the signal stalk.
3.
The turn signal will cancel when
the turn is complete.
An audible beep is associated with each
time a turn indicator is activated.
WARNING
After you complete a turn, shut the
system
off by returning the lever to the
"OFF" (center) position. Failure to shut
off a turn signal could confuse other
drivers and result in an accident. An
indicator lamp in the instrument panel
will flash until the turn signal is turned
off.
High Beam
NOTE
The headlights must be ON for the
high beam switch to operate.
• To switch your headlights to lower
or higher beam, gently pull the turn
signal lever
, toward the steering
wheel, until you hear the switch
click and the beam changes. The
blue indicator light in the instrument
panel will be ON when the high
beam is being used.
• To return to previous beam: pull the
lever towards the steering wheel
again.
• To momentarily flash your
headlights (illuminating the high-
beams), push the turn signal lever
forward.
CONTROLS - Steering Column Controls
Y53-6113-1A1 (11/20) 97
3