User Manual
Table Of Contents
- Safety
- Applies To
- Using this Manual
- Safety Alerts
- Illustrations
- General Safety Instructions
- Data Recorder
- Environmental Protection Agency
- Repairs
- Additional Sources of Information
- Cab Access
- Deckplate Access
- How to Open the Hood
- Close the Hood
- Seat
- Vehicle Loading
- Visual inspection while approaching the vehicle
- Daily Checks
- Weekly Checks
- Systems Check
- Emergency
- Controls
- Instrument Panel
- Gauges
- Warning Lights and Indicators
- Warning Lights
- Introduction
- Anti-Lock Brake System (ABS)
- Anti-Lock Brake System (ABS), Trailer
- Axle, Stability Control (Option)
- Axle, Traction Control
- Check Transmission
- Diesel Particulate Filter (DPF) Warning Light
- Differential, Inter-Axle Lock
- Dump Truck, Body Up
- Dump Truck, Trailer Body Up
- Engine BrakeSaver or Transmission Retarder
- Engine, Brake ON/OFF
- Engine, Brake Level
- Engine, Check Engine
- Engine, Engine Block Heater
- Engine, Low Coolant Level
- Engine, Overspeed
- Engine, Retarder (Brake)
- Engine, Stop Engine
- Engine, Wait To Start
- Emissions, Engine Derate
- Emissions, High Exhaust System Temperature
- Fifth Wheel Locked
- Fifth Wheel Unlocked
- Fifth Wheel Slide Unlocked
- Hill Hold (Eaton Ultrashift Plus)
- Lane Departure Warning (LDW)
- Lights, High Beam
- Malfunction Indicator Lamp (MIL)
- Message Waiting
- Park Brake
- Seat Belt, Fasten
- Transmission, Oil Temperature High
- Turn Signal, Left
- Turn Signal, Right
- Worn brake
- Menu Control Switch
- Steering Wheel Controls (Option)
- Exterior Lights Switch (ELS)
- Peterbilt Digital Display
- Display Notifications
- Views
- Menu
- Post Trip
- Dash Switches
- Axle, Automatic Traction Control
- Axle, Diff-Lock - Dual
- Axle, Diff-Lock - Forward Rear
- Axle, Diff-Lock - Steer
- Axle, Diff-Lock - Rear Rear
- Axle, Diff-Lock - Single Rear
- Axle, Inter-Axle Differential Locked (Tandem)
- Axle, Two Speed
- Back Up Alarm Mute
- Batteries, Low Voltage Disconnect (LVD)
- Brakes, ABS Off-Road
- Brakes, Parking Brake Valve
- Brake, Trailer Hand
- Cab and Panel Dimmer Switch
- Dump Truck Gate
- Engine, Brake Level
- Engine, Brake On/Off
- Engine, Cruise Control On/Off
- Engine, Cruise Control Set/Resume
- Engine Fan Override
- Engine, Heater
- Engine, Remote Throttle
- Engine, Shutdown
- Exhaust, Brake On/Off
- Exhaust, Diesel Particulate Filter (DPF) Regeneration
- Fifth Wheel Slide
- Fuel Heater
- Generic Air, Accessory
- Generic, Spare SPARE
- Kingpin Release
- Lane Departure Warning Disable
- Ignition Key Switch
- Lights, Beacon
- Lights, Daytime Running (Override)
- Lights, Flood
- Lights, Flood ISO 3732 Spare
- Lights, Fog
- Lights, Footwell (option)
- Lights, Hazard
- Lights, Spot
- Pintle Hook
- Power Take-off (PTO)
- Suspension, Air Retention
- Suspension, Axle, Pusher
- Suspension, Axle, Tag
- Suspension, Lift
- Suspension, Third Axle Lift
- Trailer Air Supply
- Trailer, Axle (3rd Axle) Lift
- Trailer, Axle Lift Forward
- Trailer, Axle Lift Rear
- Trailer, Belly Dump
- Trailer Dump Gate
- Trailer, Belly Dump Gate Center
- Trailer, Belly Dump Gate Front
- Trailer, Belly Dump Gate Rear
- Trailer, Hotline
- Trailer, Suspension Air Dump
- Winch Clutch
- Steering Column Controls
- Door Mounted Mirror Controls
- Ignition Key Switch
- Exterior Lighting Self-Test (ELST)
- Heating and Air Conditioning
- Cab Accessories
- Driving
- Starting and Operating
- Starting and Warming Up
- Engine Operations
- Transmission
- Hydraulic Brakes
- Air Brake System (option)
- Brake Safety and Emergency
- Retarders
- Axle and Suspension
- Fifth Wheel
- Driving Tips and Techniques
- Stopping the Vehicle
- Antilock Brake Systems (ABS)
- Maintenance
- New Vehicle Maintenance Schedule
- First Day
- First 50-100 mi / 80-160 km
- First 500 mi / 800 km
- First 2,000 mi / 3,218 km
- First 3,000-5,000 mi / 4,800-8,000 km
- Preventive Maintenance Intervals
- Fender Liners
- Lubricants
- Air System
- Dual Air System Function Test
- Air Dryer Maintenance
- Air Tanks
- Air Gauges and Air Leaks
- Air Compressor
- Brake System
- Cab Maintenance
- Safety Restraint System - Inspection
- Cooling System Maintenance
- Windshield Wiper/Washer
- Electrical System
- Engine Aftertreatment System Power Requirements
- Low Voltage Disconnect (LVD) (option)
- LVD Setup
- Fuses, Circuit Breakers and Relays
- Adding Electrical Options
- Maximum Number of Lamps Allowed per Circuit
- Vehicle CAN Bus
- Batteries
- Under Cab Battery Access
- In Cab Battery Access
- Cranking Battery Specification
- Removing Batteries
- Installing Batteries
- Replace Battery Box Cover
- Slow Battery Charging
- Alternator
- Remote Keyless Entry
- Engine Maintenance
- Fuel System
- Frame
- Front Axle and Suspension
- Heater and Air Conditioner Maintenance
- Noise and Emission Control
- Diesel Exhaust Fluid Tank
- Rear Axle and Suspension
- Rear Axle Alignment
- Steering System
- Driveline
- Tires
- Wheels
- Transmission Maintenance
- Hydraulic Clutch
- Specification Reference Charts
- Information
- Glossary
- Index
Where are the Fuses
Located?
Fuses for the cab are located in the fuse
panel behind the drivers side kick panel.
Main power relays are located on the
power distribution center, in the engine
compartment, mounted to the front wall of
the cab.
How to Jump Start a
Battery
Jump starting a vehicle is not a
recommended practice due to the various
battery installations and electrical options.
However, if the vehicle battery is
discharged (dead), the vehicle may be
jump started (using energy from a good
battery in another vehicle).
WARNING
Batteries contain acid that can burn
and gases that can explode. Ignoring
safety procedures may result in death,
personal injury, equipment or property
damage.
WARNING
Never jump start a battery near fire,
flames,
or electrical sparks. Batteries
generate explosive gases that could
explode. Keep sparks, flames, and
lighted cigarettes away from batteries.
Failure to comply may result in proper-
ty damage, personal injury, or death.
WARNING
Never remove or tamper with battery
caps.
Ignoring this could allow battery
acid to contact eyes, skin, fabrics, or
painted surfaces. Failure to comply
may result in death, personal injury,
equipment or property damage. Be
careful that metal tools (or any metal in
contact with the positive terminal) do
not contact the positive battery termi-
nal and any other metal on the vehicle
at the same time. Remove metal jew-
elry and avoid leaning over the battery.
WARNING
When jump starting using a battery
charger/booster
, verify that the battery
charger/booster is set to the same jump
start voltage and amperage specifica-
tions as the vehicle electrical system
and batteries (i.e., if the vehicle electri-
cal system is a 12 volt system, the jump
start voltage on the battery charger/
booster shall be set at no higher than a
12 volt setting). Failure to comply may
cause an explosion and/or fire resulting
in death, personal injury, and/or equip-
ment or property damage.
WARNING
Heed all warnings and instructions of
the
jumper cable manufacturer. Failure
to comply may result in death, person-
al injury, equipment or property dam-
age.
EMERGENCY - Where are the Fuses Located?
34 Y53-6113-1A1 (11/20)
2










