User Manual
Table Of Contents
- Safety
- Applies To
- Using this Manual
- Safety Alerts
- Illustrations
- General Safety Instructions
- Data Recorder
- Environmental Protection Agency
- Repairs
- Additional Sources of Information
- Cab Access
- Deckplate Access
- How to Open the Hood
- Close the Hood
- Seat
- Vehicle Loading
- Visual inspection while approaching the vehicle
- Daily Checks
- Weekly Checks
- Systems Check
- Emergency
- Controls
- Instrument Panel
- Gauges
- Warning Lights and Indicators
- Warning Lights
- Introduction
- Anti-Lock Brake System (ABS)
- Anti-Lock Brake System (ABS), Trailer
- Axle, Stability Control (Option)
- Axle, Traction Control
- Check Transmission
- Diesel Particulate Filter (DPF) Warning Light
- Differential, Inter-Axle Lock
- Dump Truck, Body Up
- Dump Truck, Trailer Body Up
- Engine BrakeSaver or Transmission Retarder
- Engine, Brake ON/OFF
- Engine, Brake Level
- Engine, Check Engine
- Engine, Engine Block Heater
- Engine, Low Coolant Level
- Engine, Overspeed
- Engine, Retarder (Brake)
- Engine, Stop Engine
- Engine, Wait To Start
- Emissions, Engine Derate
- Emissions, High Exhaust System Temperature
- Fifth Wheel Locked
- Fifth Wheel Unlocked
- Fifth Wheel Slide Unlocked
- Hill Hold (Eaton Ultrashift Plus)
- Lane Departure Warning (LDW)
- Lights, High Beam
- Malfunction Indicator Lamp (MIL)
- Message Waiting
- Park Brake
- Seat Belt, Fasten
- Transmission, Oil Temperature High
- Turn Signal, Left
- Turn Signal, Right
- Worn brake
- Menu Control Switch
- Steering Wheel Controls (Option)
- Exterior Lights Switch (ELS)
- Peterbilt Digital Display
- Display Notifications
- Views
- Menu
- Post Trip
- Dash Switches
- Axle, Automatic Traction Control
- Axle, Diff-Lock - Dual
- Axle, Diff-Lock - Forward Rear
- Axle, Diff-Lock - Steer
- Axle, Diff-Lock - Rear Rear
- Axle, Diff-Lock - Single Rear
- Axle, Inter-Axle Differential Locked (Tandem)
- Axle, Two Speed
- Back Up Alarm Mute
- Batteries, Low Voltage Disconnect (LVD)
- Brakes, ABS Off-Road
- Brakes, Parking Brake Valve
- Brake, Trailer Hand
- Cab and Panel Dimmer Switch
- Dump Truck Gate
- Engine, Brake Level
- Engine, Brake On/Off
- Engine, Cruise Control On/Off
- Engine, Cruise Control Set/Resume
- Engine Fan Override
- Engine, Heater
- Engine, Remote Throttle
- Engine, Shutdown
- Exhaust, Brake On/Off
- Exhaust, Diesel Particulate Filter (DPF) Regeneration
- Fifth Wheel Slide
- Fuel Heater
- Generic Air, Accessory
- Generic, Spare SPARE
- Kingpin Release
- Lane Departure Warning Disable
- Ignition Key Switch
- Lights, Beacon
- Lights, Daytime Running (Override)
- Lights, Flood
- Lights, Flood ISO 3732 Spare
- Lights, Fog
- Lights, Footwell (option)
- Lights, Hazard
- Lights, Spot
- Pintle Hook
- Power Take-off (PTO)
- Suspension, Air Retention
- Suspension, Axle, Pusher
- Suspension, Axle, Tag
- Suspension, Lift
- Suspension, Third Axle Lift
- Trailer Air Supply
- Trailer, Axle (3rd Axle) Lift
- Trailer, Axle Lift Forward
- Trailer, Axle Lift Rear
- Trailer, Belly Dump
- Trailer Dump Gate
- Trailer, Belly Dump Gate Center
- Trailer, Belly Dump Gate Front
- Trailer, Belly Dump Gate Rear
- Trailer, Hotline
- Trailer, Suspension Air Dump
- Winch Clutch
- Steering Column Controls
- Door Mounted Mirror Controls
- Ignition Key Switch
- Exterior Lighting Self-Test (ELST)
- Heating and Air Conditioning
- Cab Accessories
- Driving
- Starting and Operating
- Starting and Warming Up
- Engine Operations
- Transmission
- Hydraulic Brakes
- Air Brake System (option)
- Brake Safety and Emergency
- Retarders
- Axle and Suspension
- Fifth Wheel
- Driving Tips and Techniques
- Stopping the Vehicle
- Antilock Brake Systems (ABS)
- Maintenance
- New Vehicle Maintenance Schedule
- First Day
- First 50-100 mi / 80-160 km
- First 500 mi / 800 km
- First 2,000 mi / 3,218 km
- First 3,000-5,000 mi / 4,800-8,000 km
- Preventive Maintenance Intervals
- Fender Liners
- Lubricants
- Air System
- Dual Air System Function Test
- Air Dryer Maintenance
- Air Tanks
- Air Gauges and Air Leaks
- Air Compressor
- Brake System
- Cab Maintenance
- Safety Restraint System - Inspection
- Cooling System Maintenance
- Windshield Wiper/Washer
- Electrical System
- Engine Aftertreatment System Power Requirements
- Low Voltage Disconnect (LVD) (option)
- LVD Setup
- Fuses, Circuit Breakers and Relays
- Adding Electrical Options
- Maximum Number of Lamps Allowed per Circuit
- Vehicle CAN Bus
- Batteries
- Under Cab Battery Access
- In Cab Battery Access
- Cranking Battery Specification
- Removing Batteries
- Installing Batteries
- Replace Battery Box Cover
- Slow Battery Charging
- Alternator
- Remote Keyless Entry
- Engine Maintenance
- Fuel System
- Frame
- Front Axle and Suspension
- Heater and Air Conditioner Maintenance
- Noise and Emission Control
- Diesel Exhaust Fluid Tank
- Rear Axle and Suspension
- Rear Axle Alignment
- Steering System
- Driveline
- Tires
- Wheels
- Transmission Maintenance
- Hydraulic Clutch
- Specification Reference Charts
- Information
- Glossary
- Index
Installing Batteries
Follow the procedure below to reinstall
main batteries on the vehicle:
NOTE
Always dispose of automotive batter-
ies
in a safe and responsible manner.
Contact your authorized dealer for dis-
posal standards. Call your local au-
thorized recycling center for informa-
tion on recycling automotive batteries.
NOTE
Make sure to reconnect the ground
(negative) cable last.
WARNING
Battery replacement may alter or dis-
turb battery cable routing. Check to in-
sure battery cables are free from any
point of chaffing. Failure to comply
may result in death, personal injury,
equipment or property damage.
1. Place batteries in vehicle and
tighten bolt of holding plate
2.
Reconnect positive cable
3. Reconnect ground (negative)
ground cable
Replace Battery Box Cover
WARNING
Always reinstall steps before entering
the
cab or accessing the deck plate.
Without steps you could slip and fall.
Failure to comply may result in person-
al injury or death.
WARNING
Fairings not installed properly could
come
loose and cause other motorists
to have an injury accident. It is impor-
tant that fairings be installed properly.
Failure to comply may result in death,
personal injury, equipment or property
damage.
1. Replace battery cover.
2.
Install two bolts in step strut.
Torque to 24-32 lb-ft (33-43 N·m).
3. Install fairing and install four bolts.
T
orque to 6-7 lb-ft (8-9 N·m).
4. Install steps by installing two bolts
in each step. Torque to 24-32 lb-ft
(33-43 N·m).
Slow Battery Charging
WARNING
Charger cables must be connected
positive
to positive (+ to +) and nega-
tive to negative (- to -). If connected
improperly, batteries could explode.
Failure to comply may result in proper-
ty damage, personal injury, or death.
WARNING
Always make sure the battery charger
is
OFF before connecting or discon-
necting the cable clamps. To reduce
the danger of explosions and resulting
death or personal injury, do not con-
nect or disconnect charger cables
while the charger is operating.
MAINTENANCE - Electrical System
Y53-6113-1A1 (11/20) 239
5