User Manual
Table Of Contents
- Safety
- Applies To
- Using this Manual
- Safety Alerts
- Illustrations
- General Safety Instructions
- Data Recorder
- Environmental Protection Agency
- Repairs
- Additional Sources of Information
- Cab Access
- Deckplate Access
- How to Open the Hood
- Close the Hood
- Seat
- Vehicle Loading
- Visual inspection while approaching the vehicle
- Daily Checks
- Weekly Checks
- Systems Check
- Emergency
- Controls
- Instrument Panel
- Gauges
- Warning Lights and Indicators
- Warning Lights
- Introduction
- Anti-Lock Brake System (ABS)
- Anti-Lock Brake System (ABS), Trailer
- Axle, Stability Control (Option)
- Axle, Traction Control
- Check Transmission
- Diesel Particulate Filter (DPF) Warning Light
- Differential, Inter-Axle Lock
- Dump Truck, Body Up
- Dump Truck, Trailer Body Up
- Engine BrakeSaver or Transmission Retarder
- Engine, Brake ON/OFF
- Engine, Brake Level
- Engine, Check Engine
- Engine, Engine Block Heater
- Engine, Low Coolant Level
- Engine, Overspeed
- Engine, Retarder (Brake)
- Engine, Stop Engine
- Engine, Wait To Start
- Emissions, Engine Derate
- Emissions, High Exhaust System Temperature
- Fifth Wheel Locked
- Fifth Wheel Unlocked
- Fifth Wheel Slide Unlocked
- Hill Hold (Eaton Ultrashift Plus)
- Lane Departure Warning (LDW)
- Lights, High Beam
- Malfunction Indicator Lamp (MIL)
- Message Waiting
- Park Brake
- Seat Belt, Fasten
- Transmission, Oil Temperature High
- Turn Signal, Left
- Turn Signal, Right
- Worn brake
- Menu Control Switch
- Steering Wheel Controls (Option)
- Exterior Lights Switch (ELS)
- Peterbilt Digital Display
- Display Notifications
- Views
- Menu
- Post Trip
- Dash Switches
- Axle, Automatic Traction Control
- Axle, Diff-Lock - Dual
- Axle, Diff-Lock - Forward Rear
- Axle, Diff-Lock - Steer
- Axle, Diff-Lock - Rear Rear
- Axle, Diff-Lock - Single Rear
- Axle, Inter-Axle Differential Locked (Tandem)
- Axle, Two Speed
- Back Up Alarm Mute
- Batteries, Low Voltage Disconnect (LVD)
- Brakes, ABS Off-Road
- Brakes, Parking Brake Valve
- Brake, Trailer Hand
- Cab and Panel Dimmer Switch
- Dump Truck Gate
- Engine, Brake Level
- Engine, Brake On/Off
- Engine, Cruise Control On/Off
- Engine, Cruise Control Set/Resume
- Engine Fan Override
- Engine, Heater
- Engine, Remote Throttle
- Engine, Shutdown
- Exhaust, Brake On/Off
- Exhaust, Diesel Particulate Filter (DPF) Regeneration
- Fifth Wheel Slide
- Fuel Heater
- Generic Air, Accessory
- Generic, Spare SPARE
- Kingpin Release
- Lane Departure Warning Disable
- Ignition Key Switch
- Lights, Beacon
- Lights, Daytime Running (Override)
- Lights, Flood
- Lights, Flood ISO 3732 Spare
- Lights, Fog
- Lights, Footwell (option)
- Lights, Hazard
- Lights, Spot
- Pintle Hook
- Power Take-off (PTO)
- Suspension, Air Retention
- Suspension, Axle, Pusher
- Suspension, Axle, Tag
- Suspension, Lift
- Suspension, Third Axle Lift
- Trailer Air Supply
- Trailer, Axle (3rd Axle) Lift
- Trailer, Axle Lift Forward
- Trailer, Axle Lift Rear
- Trailer, Belly Dump
- Trailer Dump Gate
- Trailer, Belly Dump Gate Center
- Trailer, Belly Dump Gate Front
- Trailer, Belly Dump Gate Rear
- Trailer, Hotline
- Trailer, Suspension Air Dump
- Winch Clutch
- Steering Column Controls
- Door Mounted Mirror Controls
- Ignition Key Switch
- Exterior Lighting Self-Test (ELST)
- Heating and Air Conditioning
- Cab Accessories
- Driving
- Starting and Operating
- Starting and Warming Up
- Engine Operations
- Transmission
- Hydraulic Brakes
- Air Brake System (option)
- Brake Safety and Emergency
- Retarders
- Axle and Suspension
- Fifth Wheel
- Driving Tips and Techniques
- Stopping the Vehicle
- Antilock Brake Systems (ABS)
- Maintenance
- New Vehicle Maintenance Schedule
- First Day
- First 50-100 mi / 80-160 km
- First 500 mi / 800 km
- First 2,000 mi / 3,218 km
- First 3,000-5,000 mi / 4,800-8,000 km
- Preventive Maintenance Intervals
- Fender Liners
- Lubricants
- Air System
- Dual Air System Function Test
- Air Dryer Maintenance
- Air Tanks
- Air Gauges and Air Leaks
- Air Compressor
- Brake System
- Cab Maintenance
- Safety Restraint System - Inspection
- Cooling System Maintenance
- Windshield Wiper/Washer
- Electrical System
- Engine Aftertreatment System Power Requirements
- Low Voltage Disconnect (LVD) (option)
- LVD Setup
- Fuses, Circuit Breakers and Relays
- Adding Electrical Options
- Maximum Number of Lamps Allowed per Circuit
- Vehicle CAN Bus
- Batteries
- Under Cab Battery Access
- In Cab Battery Access
- Cranking Battery Specification
- Removing Batteries
- Installing Batteries
- Replace Battery Box Cover
- Slow Battery Charging
- Alternator
- Remote Keyless Entry
- Engine Maintenance
- Fuel System
- Frame
- Front Axle and Suspension
- Heater and Air Conditioner Maintenance
- Noise and Emission Control
- Diesel Exhaust Fluid Tank
- Rear Axle and Suspension
- Rear Axle Alignment
- Steering System
- Driveline
- Tires
- Wheels
- Transmission Maintenance
- Hydraulic Clutch
- Specification Reference Charts
- Information
- Glossary
- Index
Under Cab Battery Access
The battery compartment is located on the
left side of the vehicle, under the cab
access steps.
1.
Remove steps by removing 2 bolts
from each step.
2. Remove 4 bolts and washers from
forward fairing.
3. Remove 2 bolts (A) from step strut.
4. Remove battery cover for access.
In Cab Battery Access
Your vehicle may be equipped with
Absorbed Glass Mat (AGM) batteries
located in the cab under the passenger's
seat. The glass mat in AGM batteries are
designed to absorb the battery acid inside
the battery that can leak or spill out in
conventional batteries. This design feature
allows batteries to be positioned in any
orientation without risk of leaking.
To access the batteries:
1. Enter the cab.
2. Remove six fasteners securing the
passenger side seat base to the
battery box assembly.
3. Remove the seat and seat base as
one unit to gain access to the
batteries.
4. Installation is the reverse of
removal.
Cranking Battery Specification
Category Specification
Group 31
Stud Type Threaded
Cold Crank Amps 650
Voltage 12 V
Reserve Capacity 160 minutes
General Maintenance free
Removing Batteries
After accessing the batteries, follow these
steps to remove them from the vehicle.
CAUTION
Wait at least 10 minutes after the key
switch
is turned OFF before discon-
necting battery power. The system
uses battery power to circulate DEF
and
prevent overheating of the DEF
system. Failure to comply may result
in property damage.
1. Be sure all switches on the vehicle
are turned OFF
2.
Wait 10 minutes after turning
ignition off before disconnecting the
batteries
3. Disconnect negative (-) ground
cable first
4. Disconnect positive (+) cable
5. Unscrew the holding plate bolts
with an open end wrench
NOTE
Always dispose of automotive batter-
ies
in a safe and responsible manner.
Contact your authorized dealer for dis-
posal standards. Call your local au-
thorized recycling center for informa-
tion on recycling automotive batteries.
Follow the procedures below to reinstall
batteries on the vehicle and replace parts
removed for access.
MAINTENANCE - Electrical System
238 Y53-6113-1A1 (11/20)
5










