User Manual

a. Twist bulb socket counter-
clockwise to loosen and
remove socket and bulb from
the headlight assembly
.
b. Change the bulb in the socket.
c. Replace socket and bulb into
headlight assembly by lining
up the tab on the socket with
the slot in the headlight
housing and then insert.
d. Twist socket clockwise to lock.
Replace low beam/high beam
socket cap if removed earlier
in this step.
5. Reinstall fender liner (How to
Reinstall a Fender Liner on page
197).
6. Close and secure hood (See Close
the Hood).
Final Checks
1. After everything is reconnected,
turn on your headlights and check
for operation.
2. Have your headlights periodically
checked for proper alignment by
dealer.
3. Keep your headlights clean, using
only clean soap and water. A dirty
headlight reduces performance and
creates glare.
Aiming Headlights
The headlights were properly aimed at the
factory to meet safety specifications. If the
headlights need to be adjusted, please
have an authorized dealership aim the
headlights.
Electrical System
WARNING
Battery posts, terminals and related
accessories
contain lead and lead
compounds, chemicals known to the
State of California to cause cancer and
reproductive harm. Wash hands after
handling.
CAUTION
DO NOT modify or improperly repair
the
vehicles electrical system or power
distribution box. All electrical repairs
should be performed by an authorized
dealer
. Improper repair or modifica-
tions will void your warranty and/or
cause serious damage to your vehicle.
Engine Aftertreatment System
Power Requirements
The engine aftertreatment system uses
battery power for up to 10 minutes after the
ignition is turned of
f. After the ignition turns
off, the engine aftertreatment system
circulates DEF to help cool down the fluid
and prevent overheating. For situations
where the battery will be disconnected (i.e.
for service or maintenance of the vehicle),
please wait 10 minutes before
disconnecting battery power.
CAUTION
Wait at least 10 minutes after the key
switch is turned OFF before discon-
necting battery power. The system
uses battery power to circulate DEF
and prevent overheating of the DEF
system. Failure to comply may result
in property damage.
MAINTENANCE - Electrical System
232 Y53-6113-1A1 (11/20)
5