User Manual

Application Type Of Lubricant Mileage Interval
On Highway Synthetic 240,000 mi. (384,000 km)
Synthetic with Pump and Filter 500,000 mi. (800,000 km)
Mineral Base 120,000 mi. (192,000 km)
City Delivery Synthetic 120,000 mi. (192,000 km)
Synthetic with Pump and Filter 240,000 mi. (384,000 km)
Mineral Base 120,000 mi. (192,000 km)
Off Highway Synthetic 120,000 mi. (192,000 km)
Synthetic with Pump and Filter 120,000 mi. (192,000 km)
Mineral Base 120,000 mi. (192,000 km)
• Change the lubricant filter every
120,000 miles (192,000 km). T
op
off the lubricant level with a similar
lubricant
Eaton/Dana Axle Lubrication
• The original mineral-based
lubricant must be drained within
3,000-5,000 miles (4,800-8,000
km) on all Eaton axles. This initial
change is very important because it
flushes out break-in contaminants
that might otherwise cause
premature wear.
• No initial drain is required on Eaton
axles that are factory filled with an
Eaton-approved synthetic lubricant.
• Mineral-based lubes must be
drained within the first 5,000 miles
(8,000 km) if converting to an
Eaton-approved synthetic lube.
• Change the lubricant within the first
5,000 miles (8,000 km) of operation
after a carrier head replacement,
regardless of the lubricant type.
• Refer to the Eaton Field
Maintenance Manual for a
particular axle for lubricant
specifications.
• See your dealer for Eaton-
approved lubricant brands.
• Refer to the chart below for
lubricant change interval.
MAINTENANCE - Lubricants
202 Y53-6113-1A1 (11/20)
5