User Manual
Table Of Contents
- Safety
- Applies To
- Using this Manual
- Safety Alerts
- Illustrations
- General Safety Instructions
- Data Recorder
- Environmental Protection Agency
- Repairs
- Additional Sources of Information
- Cab Access
- Deckplate Access
- How to Open the Hood
- Close the Hood
- Seat
- Vehicle Loading
- Visual inspection while approaching the vehicle
- Daily Checks
- Weekly Checks
- Systems Check
- Emergency
- Controls
- Instrument Panel
- Gauges
- Warning Lights and Indicators
- Warning Lights
- Introduction
- Anti-Lock Brake System (ABS)
- Anti-Lock Brake System (ABS), Trailer
- Axle, Stability Control (Option)
- Axle, Traction Control
- Check Transmission
- Diesel Particulate Filter (DPF) Warning Light
- Differential, Inter-Axle Lock
- Dump Truck, Body Up
- Dump Truck, Trailer Body Up
- Engine BrakeSaver or Transmission Retarder
- Engine, Brake ON/OFF
- Engine, Brake Level
- Engine, Check Engine
- Engine, Engine Block Heater
- Engine, Low Coolant Level
- Engine, Overspeed
- Engine, Retarder (Brake)
- Engine, Stop Engine
- Engine, Wait To Start
- Emissions, Engine Derate
- Emissions, High Exhaust System Temperature
- Fifth Wheel Locked
- Fifth Wheel Unlocked
- Fifth Wheel Slide Unlocked
- Hill Hold (Eaton Ultrashift Plus)
- Lane Departure Warning (LDW)
- Lights, High Beam
- Malfunction Indicator Lamp (MIL)
- Message Waiting
- Park Brake
- Seat Belt, Fasten
- Transmission, Oil Temperature High
- Turn Signal, Left
- Turn Signal, Right
- Worn brake
- Menu Control Switch
- Steering Wheel Controls (Option)
- Exterior Lights Switch (ELS)
- Peterbilt Digital Display
- Display Notifications
- Views
- Menu
- Post Trip
- Dash Switches
- Axle, Automatic Traction Control
- Axle, Diff-Lock - Dual
- Axle, Diff-Lock - Forward Rear
- Axle, Diff-Lock - Steer
- Axle, Diff-Lock - Rear Rear
- Axle, Diff-Lock - Single Rear
- Axle, Inter-Axle Differential Locked (Tandem)
- Axle, Two Speed
- Back Up Alarm Mute
- Batteries, Low Voltage Disconnect (LVD)
- Brakes, ABS Off-Road
- Brakes, Parking Brake Valve
- Brake, Trailer Hand
- Cab and Panel Dimmer Switch
- Dump Truck Gate
- Engine, Brake Level
- Engine, Brake On/Off
- Engine, Cruise Control On/Off
- Engine, Cruise Control Set/Resume
- Engine Fan Override
- Engine, Heater
- Engine, Remote Throttle
- Engine, Shutdown
- Exhaust, Brake On/Off
- Exhaust, Diesel Particulate Filter (DPF) Regeneration
- Fifth Wheel Slide
- Fuel Heater
- Generic Air, Accessory
- Generic, Spare SPARE
- Kingpin Release
- Lane Departure Warning Disable
- Ignition Key Switch
- Lights, Beacon
- Lights, Daytime Running (Override)
- Lights, Flood
- Lights, Flood ISO 3732 Spare
- Lights, Fog
- Lights, Footwell (option)
- Lights, Hazard
- Lights, Spot
- Pintle Hook
- Power Take-off (PTO)
- Suspension, Air Retention
- Suspension, Axle, Pusher
- Suspension, Axle, Tag
- Suspension, Lift
- Suspension, Third Axle Lift
- Trailer Air Supply
- Trailer, Axle (3rd Axle) Lift
- Trailer, Axle Lift Forward
- Trailer, Axle Lift Rear
- Trailer, Belly Dump
- Trailer Dump Gate
- Trailer, Belly Dump Gate Center
- Trailer, Belly Dump Gate Front
- Trailer, Belly Dump Gate Rear
- Trailer, Hotline
- Trailer, Suspension Air Dump
- Winch Clutch
- Steering Column Controls
- Door Mounted Mirror Controls
- Ignition Key Switch
- Exterior Lighting Self-Test (ELST)
- Heating and Air Conditioning
- Cab Accessories
- Driving
- Starting and Operating
- Starting and Warming Up
- Engine Operations
- Transmission
- Hydraulic Brakes
- Air Brake System (option)
- Brake Safety and Emergency
- Retarders
- Axle and Suspension
- Fifth Wheel
- Driving Tips and Techniques
- Stopping the Vehicle
- Antilock Brake Systems (ABS)
- Maintenance
- New Vehicle Maintenance Schedule
- First Day
- First 50-100 mi / 80-160 km
- First 500 mi / 800 km
- First 2,000 mi / 3,218 km
- First 3,000-5,000 mi / 4,800-8,000 km
- Preventive Maintenance Intervals
- Fender Liners
- Lubricants
- Air System
- Dual Air System Function Test
- Air Dryer Maintenance
- Air Tanks
- Air Gauges and Air Leaks
- Air Compressor
- Brake System
- Cab Maintenance
- Safety Restraint System - Inspection
- Cooling System Maintenance
- Windshield Wiper/Washer
- Electrical System
- Engine Aftertreatment System Power Requirements
- Low Voltage Disconnect (LVD) (option)
- LVD Setup
- Fuses, Circuit Breakers and Relays
- Adding Electrical Options
- Maximum Number of Lamps Allowed per Circuit
- Vehicle CAN Bus
- Batteries
- Under Cab Battery Access
- In Cab Battery Access
- Cranking Battery Specification
- Removing Batteries
- Installing Batteries
- Replace Battery Box Cover
- Slow Battery Charging
- Alternator
- Remote Keyless Entry
- Engine Maintenance
- Fuel System
- Frame
- Front Axle and Suspension
- Heater and Air Conditioner Maintenance
- Noise and Emission Control
- Diesel Exhaust Fluid Tank
- Rear Axle and Suspension
- Rear Axle Alignment
- Steering System
- Driveline
- Tires
- Wheels
- Transmission Maintenance
- Hydraulic Clutch
- Specification Reference Charts
- Information
- Glossary
- Index
Every 15,000 mi / 24,000 km / 12 mo
20
Drive Axle (Meritor) - Input shaft and pinion shaft
•
Check and adjust the endplay. (Refer to Drive Axle - Meritor on page 263.)
Drive Axle (Meritor) - Axle shaft
• Tighten the rear axle flange nuts to the specified torque value. (Refer to Drive Axle - Meritor on page 263.)
Drive Axle (Meritor) - Interaxle differential
• Check the operation. (Refer to Inter-Axle Differential Lock Operation on page 148 for maintenance instructions.)
Rear Suspension - U-bolts
• Check the torque. Tighten to specified torque value as required. (Refer to Suspension U-Bolts, Grade 8 on page 282.)
Rear Suspension - Frame and crossmember bolts
• Check the torque. Tighten to specified torque value as required. (Refer to Frame Fastener Torque Requirements on page 280.)
Rear Suspension - Mounting brackets and fasteners
• Check the condition and the fastener torque. Tighten to the specified torque value as required. (Refer to Frame Fastener Torque
Requirements on page 280.)
Drum Brakes (All) - Brake camshaft bearing
• Check for excessive camshaft play in the axial and radial directions. Max allowable play is 0.003 in. Lubricate (NLGI #2 grease).
(Refer to Drum Brake Inspection on page 214.)
Drum Brakes (All) - Brake treadle valve
• Clean the area around the treadle, boot, and mounting plate. Check the pivot and mounting plate for integrity. Check the plunger
boot for cracks. Lubricate roller pin, pivot pin, and plunger (NLGI #2 grease). (Refer to Drum Brake Inspection on page 214.)
20
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
MAINTENANCE - Preventive Maintenance Intervals
those listed here.
Y53-6113-1A1 (11/20) 189
5