User Manual

Every 7,500 mi / 12,000 km / 6 mo
19
Driveshafts - Models SPL-90, 1710 and 1810 slip member and U-joints
•
Lubricate
*
.
Driveshafts - Models SPL-100 slip member and U-joints
•
Lubricate
*
.
Driveshafts - Models SPL-140/140HD/170/170HD/250/250HD slip members and U-joints (OFF HIGHWAY)
•
Lubricate
*
.
Battery Boxes, Tool Boxes, and Steps - Battery cables
•
Check the condition of the cables, cushion clamps, nylon tie straps, and routing. Replace a cushion clamp if the rubber has
deteriorated. Repair or tighten terminals, and secure cables to prevent chafing. Replace damaged cables. (cuts, cracks, or
excessive wear) (Refer to Batteries on page 236 for maintenance instructions.)
Battery Boxes, Tool Boxes, and Steps - Batteries (ON HIGHWAY and LINE HAUL)
• Check for cracks and damage, electrolyte level, condition of terminals, and tightness of holddowns. (Refer to Batteries on page
236 for maintenance instructions.)
Battery Boxes, Tool Boxes, and Steps - Batteries (OFF HIGHWAY)
• Check for cracks and damage, electrolyte level, condition of terminals, and tightness of holddowns. (Refer to Batteries on page
236 for maintenance instructions.)
Battery Boxes, Tool Boxes, and Steps - Battery box and tray (ON HIGHWAY and LINE HAUL)
• Check the box integrity. Clean the drain tube and check for acid leaks. Check condition of all equipment mounted under the box.
(Refer to Batteries on page 236 for maintenance instructions.)
19
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
MAINTENANCE - Preventive Maintenance Intervals
those listed here.
Y53-6113-1A1 (11/20) 181
5