User Manual

Table Of Contents
Fog lights (option)
Driving lights (option)
Daytime Running Lights (option)
The following lights stay on during the
duration of a full test:
Clearance lights
Identification lights
Side Marker lights
Beacon/Strobe (option)
Work/Load lights (option)
Sign light (option)
Limited ELST
A limited ELST will alternately turn on and
then off the following lights:
Hazard/turn signals
Low beam headlights
High beam headlights
Park lights
Daytime running lights (option)
License plate lights
Tail lights
Stop lights
The following lights will stay on during the
duration of a limited test:
Clearance lights
Identification lights
Side marker lights
Test the Exterior Lights
For a full ELST
, the parking brake must be
set and the ignition switch must be in the
ON position. For a limited ELST, the
ignition switch must be in the ACC or OFF
position.
A full ELST will test all exterior lights (also
checking the mirror and headlight heaters if
the engine is on). A limited ELST will test
only the legal driving lights.
1. Turn the Exterior Lighting Switch
(ELS) to the momentary ELST
position and release the switch, or
The ELST icon will illuminate.
2.
Press the ELST button on the key
fob.
A full ELST will continue until the parking
brake is released or the ignition switch is
turned to OFF. Both the full and limited
ELST will stop if either the dash or key fob
ELST buttons are pressed, or the fifteen
minute test duration has elapsed.
Heating and Air
Conditioning
This vehicle's heating and air conditioning
system operates in four distinct modes:
manual, automatic, semi-automatic, and
maximum defrost. Each mode provides the
driver with the greatest level of comfort and
convenience.
The recommended mode for all conditions
that do not require windshield defrosting is
the automatic mode. This mode is capable
of maintaining cab comfort under various
driving conditions without driver interaction.
The cab heater and air conditioner controls
are located together in the center of the
dash just to the right of the steering
column. The sleeper heater and air
conditioner controls are located in the
sleeper cabinet.
CONTROLS - Heating and Air Conditioning
104 Y53-6113-1A1 (11/20)
3