OPERATOR'S MANUAL
Table Of Contents
- How to Use This Manual
- Safety Signals
- Vehicle Safety
- How to Find What You Want
- A Special Word About Repairs
- Shop Manuals
- Preventive Maintenance Section
- Additional Sources of Information
- Start–Up
- Instruments and Controls
- Introduction
- Warning Lights and Buzzer
- Self Test
- Speedometer and Odometer
- Tachometer
- Coolant (Water) Temperature Gauge
- Engine Oil Pressure Gauge
- Dual Air Pressure Gauge (Air Reservoir)
- Fuel Gauge
- Voltmeter (option)
- Transmission Temperature Gauge (option)
- Air Filter Restriction Indicator (option)
- Headlight Switch
- Daytime Running Lights (option)
- Panel Lights
- ID and Clearance Lights
- Windshield Wipers/Washer
- Ignition Key Switch
- Parking Brake
- Cruise Control Switch
- Hand Throttle Control
- Heating and Air Conditioning
- Accessories
- Seats
- Steering Column and Mirrors
- Operating the Engine
- Operating the Transmission
- Using the Brake System
- Operating the Rear/Drive Axle
- More Driving Tips and Techniques
- Vehicle Recovery and Spring Brakes
- Shut–Down
- Introduction
- Maintenance Schedule and Lubrication
- Engine Maintenance
- Cooling System
- Brake System
- Air System
- Tires and Wheels
- Heater and Air Conditioner
- Electrical System
- Cab Maintenance
- Transmission and Clutch
- Steering and Driveline
- Front Axle and Suspension
- Rear Axle and Suspension
- Frame and Fifth Wheel
- Noise and Emission Control
- Consumer Information and Vehicle Identification
Start–Up Operating Instructions
– 14 –
PB1318 3/01 Model 330
3. Fuel Filter/Water Separator Draining—check and drain.
Depending on the fuel storage facility, more frequent
draining may be required.
4. Windshield washer reservoir fluid level—fill if necessary.
5. Hood closed before entering cab. Is it latched properly?
Chassis and Cab Checks — Daily
Before entering the cab and operating the vehicle, check the
following equipment for proper maintenance:
1. Lights—do headlights, turn signals, emergency flashers,
and exterior lamps function and are they clean and
adjusted properly?
2. Windows and Mirrors—are they clean and adjusted
properly?
3. Tires and Wheels—are they inflated properly? Are all
wheel cap nuts in place and torqued properly—tighten if
necessary. Check front wheel bearing oil levels. Inspect
all tires and wheels for damage—correct if found.
4. Suspension—check for loose or missing fasteners.
Check damage to springs or other suspension parts.
5. Brake Components—check lines, linkages, chambers,
and brake operation.
6. If your truck has hydraulic brakes, check:
• the brake system for leaks
• hydraulic lines for cracks or kinks
• calipers for leaks
7. Air System—are there leaks?
• Air Tanks—drain water from all air tanks. Make sure
the drain cocks are closed. This procedure is also
required for air suspension tanks equipped with
automatic drain valves.
• See
page 70
for further details on “Using the Brake
System.”
8. Steps and Handholds—check for worn surfaces and
loose or missing fasteners.
9. Fluid Tanks—check underneath the vehicle for signs of
fluid leaks. If any are found, correct before operating the
vehicle.
10. Fuel Tank Caps—are they secure?
WARNING! Diesel fuel in the presence of an igni-
tion source (such as a cigarette) could cause an
explosion. You could be seriously injured. A
mixture of gasoline or alcohol with diesel fuel
increases this risk of explosion.
• Do not remove a fuel tank cap near an open
flame.
• Use only the fuel and/or additives recommended
for your engine.










