OPERATOR'S MANUAL

Table Of Contents
Cab, Instruments and Controls
59
F. TRIP METER RESET BUTTON
The trip meter is set to zero with the reset button.
G. ODOMETER AND TRIP METER
The total distance is displayed in "km" or "mls" in the top section of the display.
H. WARNING INDICATORS
See section concerned.
I. and J. AIR PRESSURE GAUGE, CIRCUITS 1 AND 2
Each gauge indicates the air pressure in the reservoirs of one of the service brake
circuits. If the pressure in one of the circuits drops below approx. 5 bar, an acoustic
signal is generated and the warning symbol "Air system pressure too low" will
illuminate in the master display. When the pressure is higher than 7 bar, the brakes
can be released with the parking brake lever. The acoustic signal and warning
symbol are only generated when the contact is on. The gauges also operate when
the contact is off.
The vehicle must not be driven when the acoustic signal sounds or when the
pressure in one of the circuits is lower than approx. 5 bar.
K. OUTSIDE TEMPERATURE AND CLOCK
The display is activated when the contact is on.
The clock is shown in the top section of the display.
The outside temperature is displayed in the bottom section in C or F.