OPERATOR'S MANUAL

Table Of Contents
Alarm System
33
The system is now fully operational.
Ensure that there is nothing in the interior that can cause a false alarm, e.g. moving
objects in the cab.
Pressing the button (2) on the hand-held transmitter results in the system
deactivating itself. This is indicated visually by the warning lights lighting up 3 times.
SELF-DIAGNOSIS
The electronic anti-theft system has an extensive self-diagnostic function. Following
activation, all detection circuits (for the interior, grille, cab tilting mechanism and
doors) are automatically tested.
If a fault is found in one or more of these detection circuits, the affected circuit(s) is
(are) switched off. This is made noticeable by a short signal from the siren
immediately after activation of the alarm system.
If this signal is heard, first of all check whether the windows and/or doors are closed
properly.
Turn the alarm system off, close everything carefully and switch on the alarm
system again. If the short signal is heard once again, this means that the system is
(partially) defective. You should then have the system looked at by your authorized
Service dealer.