operators_manual

5. Fill cap
• If you check the fluid with the
engine and steering system
COLD, the fluid level should be
above the Add indicator level
and should generally not
exceed the middle point
between the Add and Full level
indicators.
•
If you check the fluid with the
engine and steering system
WARM, the fluid should NOT
exceed the Full level indicator
and should generally not drop
below the middle point between
the HOT Full and Add level
indicators.
4. To add fluid, open the fill cap to the
power steering reservoir and then
add fluid until the fluid level is in the
middle of the appropriate Minimum
and Maximum level indicators.
5. Reinstall the reservoir fill cap and
close the hood.
Steering Shaft Bolt Torque
Specifications
The steering (intermediate shaft) U-joint
pinch bolt should be tightened on the first
day or two of operation, then checked
weekly (see W
eekly Checks). The
following are common torque specifications
for most steering shafts.
Steering U-joint Pinch Bolt
Fastener Size Torque Spec. lb-ft
(N•m)
7/16 -in. 37-43 (50-58)
Pitman Arm Clamp Bolt
Fastener Size Torque Spec. lb-ft
(N•m)
3/4 -in. 300-320 (406-433)
WARNING
If this chassis is equipped with an
Electronic
Stability Control (ESC) and
is modified (e.g. adding or removing
an axle, converting from a truck to a
tractor, converting from a tractor to a
truck, changing the body, lengthening
of the wheelbase and/or frame, relo-
cating frame components, or modifying
pneumatic or electrical ABS/ESC har-
nesses) the ESC must be evaluated
by a qualified technician. If you have
any questions, contact your authorized
dealer. Failure to comply may result in
property damage, personal injury, or
death.
Driveline
See the driveshaft manufacturer's
operator's manual for lubrication
specifications and service intervals.
MAINTENANCE - Driveline
Y53-6110-1A1 (01/21) 291
5