operators_manual

Headlight Assembly
1. Turn signal socket
2.
Low beam bulb access cap
3. Daytime running light (DRL) and
parking light socket
4. Adjustment knob (Dealer use
ONLY)
5. High beam bulb access cap
CAUTION
When replacing a halogen bulb, do not
touch
the globe with your fingers. Oils
or other contaminates on the skin can
result in early bulb failure.
1. Open the hood and secure it in the
open position.
2.
Locate and open the access panel
on the inside of the fender liner
(see Access Door graphic).
3. If replacing the low or high beam
bulb, unscrew and remove the
access cap covering that bulb: (2)
or (5).
4. Unlock bulb from behind by turning
socket (and its wired connector) a
quarter-turn counterclockwise, then
withdraw bulb and socket from
seat.
5. Pull bulb from socket and insert
replacement. Dispose of old bulb.
Do not touch bulb globe with
fingers.
6. Reinsert bulb and socket by lining
up the tab on the socket with the
slot in the headlight housing, then
insert and turn clockwise to lock.
7. Replace access cap if removed
earlier in this procedure.
8.
Replace the access panel, then
close and secure the hood.
Final Checks
• After everything is reconnected,
check the replaced light for
operation.
• Have your headlights periodically
checked for proper alignment by
dealer.
• Keep your headlights clean using
only mild soap and water (see
Maintaining Headlight
Performance). A dirty headlight
reduces performance and creates
glare.
Aiming Headlights
The headlights were properly aimed at the
factory to meet safety specifications. If the
headlights need to be adjusted, please
have an authorized dealership aim the
headlights.
Fuses, Circuit Breakers and Relays
Fuses, circuit breakers, and relays are
located in the Power Distribution Center
(PDC) to the left of the steering column,
MAINTENANCE - Electrical System
Y53-6110-1A1 (01/21) 259
5