operators_manual

Every 60,000 mi / 96,000 km / 6 Months
12
Fuel and Tanks - Fuel Tanks
•
Inspect tanks, brackets, hoses, and fittings for correct location, tightness, abrasion damage, and leaks: repair or replace as
required. (Refer to Fuel Tank on page 275 for maintenance instructions.)
Driveshafts - Models SPL- 140/140HD/170/170HD/250/250HD Slip Members and U- joints (ON HIGHWAY and LINEHAUL)
• Lubricate
*
Battery Boxes, Tool Boxes, and Steps - Batteries (ON HIGHWAY and LINE HAUL)
•
Check for cracks and damage, electrolyte level, condition of terminals, and tightness of hold downs. Refer to Batteries on page
261 for maintenance instructions.
Battery Boxes, Tool Boxes, and Steps - Battery Box and Tray (ON HIGHWAY and LINE HAUL)
• Check the box integrity. Clean the drain tube and check for acid leaks. Check condition of all equipment mounted under the box.
Check the drain tube and check for acid leaks. Check condition of all equipment mounted under the box. (Refer to Batteries on
page 261 for maintenance instructions.)
Electrical and Lights - Alternator
• Check operation and output. (Refer to Alternator on page 265
• Check tightness of the pulley nut. (Refer to Install Engine Belt on page 269 for maintenance instructions.)
• Check the tension of the drive belt. (Refer to Install Engine Belt on page 269 for maintenance instructions.)
• Check tightness of the terminal hex nuts. (Refer to Install Engine Belt on page 269 for maintenance instructions.)
Electrical and Lights - Starter
• Check torque on hex nuts. (Refer to Electrical System on page 256 for maintenance instructions.)
12
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
those listed here.
*
Use only Spicer Driveshaft approved lubricants when greasing Spicer U-joints.
MAINTENANCE - Every 60,000 mi / 96,000 km / 6 Months
222 Y53-6110-1A1 (01/21)
5