operators_manual

Every 15,000 mi / 24,000 km / Monthly
10
Driveshafts - Models SPL-90, 1710 and 1810 Slip Member and U-joints
•
Lubricate
Driveshafts - Model SPL-100 Slip Member and U-joints
• Check the condition of the cables, cushion clamps, nylon tie straps, and routing. Replace a cushion clamp if the rubber has
deteriorated. Repair or tighten terminals, and secure cables to prevent chafing. Replace damaged cables (cuts, cracks, or
excessive wear.) (Refer to Batteries on page 261 for maintenance instructions.)
Battery Boxes, Tool Boxes, and Steps - Battery Cables Battery Boxes, Tool Boxes, and Steps - Batteries (OFF-HIGHWAY)
• Check for cracks and damage, electrolyte level, condition of terminals, and tightness of hold downs. (Refer to Batteries on page
261 for maintenance instructions.)
Battery Boxes, Tool Boxes, and Steps - Battery Box and Tray (OFF-HIGHWAY)
• Check the box integrity. Clean the drain tube and check for acid leaks. Check condition of all equipment mounted under the box.
(Refer to Batteries on page 261 for maintenance instructions.)
Battery Boxes, Tool Boxes, and Steps - Battery Cable Fasteners
• Check battery cable fasteners and tighten as necessary to 10-15 lb-ft (13.6-20.3 N·m) as specified on the battery label. (Refer to
Batteries on page 261 for maintenance instructions.)
Electrical and Lights - Warning Lights in Light Bar
• Check at the ignition start position to verify bulb check and systems check function. (Refer to Bulb Check on page 79 for
maintenance instructions.)
10
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
those listed here.
*
Use only Spicer Driveshaft approved lubricants when greasing Spicer U-joints.
MAINTENANCE - Every 15,000 mi / 24,000 km / Monthly
Y53-6110-1A1 (01/21) 209
5