operators_manual

Table Of Contents
included with your vehicle for instructions
on how to change shift configurations.
T
ransmission Gear Display
Gear Display Icon (gear number)
This indicator will show the transmission
mode and current gear
.. This does not
apply to vehicles with Allison Automatic
transmissions.
Max mode
Low gear mode
Manual Mode
Neutral Coast
Driver Shift Aid
Configuration 2
Inside the gear icon, the indicator normally
show the current gear number and may at
times show:
AN - Auto Neutral
CA - Clutch Abuse
GI - Grease Service Interval
! - Error State
Gear Display Icon (Error State)
This icon indicates an error in the
transmission.. Attempt to reset the
transmission by turning of
f the vehicle.
After two minutes, restart the engine and
see if the same icon appears in the display.
Please contact your nearest Authorized
dealership if the condition persists.
Controls for Vehicles with an Eaton
Automated or a PACCAR
Transmission
This vehicle may be equipped with either
an Eaton Automated or a PACCAR
Transmission. The Automated or PACCAR
Transmission controls are located on the
right hand side of the steering column.
Using the Manual - Automatic
Button
This button will put the transmission into
manual mode. Manual mode will allow the
operator to select the gear
. See Up or
Down Shifting on page 158.
To activate, put the gear selector in the D
(drive) mode and then depress the M/A
button. The instrument cluster will display
the corresponding selection in the
transmission mode area of the display. See
Drive, Neutral, and Reverse Indicator on
DRIVING - Transmission
Y53-6110-1A1 (01/21) 157
4