operators_manual

highway departure prior to the braking
action taken during a HDB event (see Lane
Departure W
arning).
The operator can acknowledge and cancel
a Highway Departure Braking (HDB) event
by
• Applying the service brake and
braking more than that applied by
HDB.
• Pressing the accelerator pedal and
pressing more than 90% of the
pedal range.
• Activating the turn signal.
• Activating the hazards.
• Steering the vehicle back into the
lane.
signs. The detected, posted speed limit is
presented on the display using a road sign
located in the Driver Assistance area (see
Minimized View with Driver Assistance):
When vehicle speed exceeds the posted
speed limit by 5 mph (8 kph) or more, the
operator is notified using alternating red
and blue “cop” lights, indicating above the
sign on the display
. This is accompanied
by an audible alert.
Please read the ADAS OEM operator’s
manual specific for your vehicle for more
information about Speed Limit Recognition.
Transmission
Transmission Tips
Riding the Clutch
The clutch is not a footrest. DO NOT drive
with your foot resting on the clutch pedal. It
will allow your clutch to slip, causing
excessive heat and wear, damage could
result.
Release Bearing Wear
When you must idle your engine for any
period of time, shift your transmission to
neutral and disengage the clutch (take your
foot OFF of the pedal). This helps prevent
unnecessary wear to your clutch release
bearing, and is less tiring for you, too.
More T
ips
• Always use the clutch when
making upshifts or downshifts.
• Always select a starting gear that
will provide sufficient gear
reduction for the load and terrain.
• Never downshift when the vehicle
is moving too fast.
• Never slam or jerk the shift lever to
complete gear engagement.
• Never coast with the transmission
in neutral and the clutch
disengaged. To provide smooth
gear engagements while shifting,
use proper coordination between
shift lever and clutch.
• Double clutching is a very effective
means to increase the service life
of your transmission. Double
clutching refers to a technique
where the clutch pedal is used
twice per shift instead of once. It
DRIVING - Transmission
To prevent abuse of this feature, after six
Highway Departure Braking events, HDB
will be disabled until the next time the
ignition switch is cycled. This is to prevent
using HDB irresponsibly or in a manner for
which it was not intended. Please read the
ADAS OEM operator’s manual specific for
your vehicle for more information about
Highway Departure Braking.
Speed Limit Recognition
Using the forward camera of your Driver
Assistance instrumentation, your vehicle
can read most North American speed limit
Y53-6110-1A1 (01/21) 153
4