operators_manual

The operator may also use the trip
summary to view the same information Trip
Summary on page 72.
Driver Profile Indicator
The number following the icon indicates
which driver is active when Driver Profiles
are enabled. For information on Driver
Profiles, Choosing the Active Driver Profile
on page 74.
Odometer
The odometer displays the total distance
your vehicle has traveled. The maximum
distance that can be shown on the
odometer is 9,999,999.9. The odometer
will roll over to zero if maximum mileage is
achieved.
Engine Hours
Engine hours will display the total number
of hours the engine has been operated.
The maximum hours that can be shown
are 99,999.9 before the counter rolls over
to zero.
Battery Voltage
The Battery Voltage indicator shows the
battery icon, voltage, and the state of
charge. The battery icon will be replaced
with the Low Voltage Disconnect (LVD)
icon when Low Voltage Disconnect is
active. The battery icon is gray when
operating normally, but changes to amber
to indicate a low voltage condition and red
to indicate a high or very low voltage
condition.
Clock
The clock can be displayed in a 12-hour or
24-hour format. Clock settings can be
altered in the Settings Sub-menu.
Transmission Gear Display
Vehicles with PACCAR or Eaton
automated transmissions will show the
transmission mode, current gear, and
diagnostic information associated with the
transmission. Vehicles with manual
transmissions will show the current gear.
This display does not apply for vehicles
with Allison transmissions.
Selecting a View
The instrument cluster has 5 views for the
operator to use.
• Favorites
• Minimized
• (Optional) Minimized with
Advanced Driver Assistant
• Basic View
• Enhanced View
Each view is identified by a specific view
indicator on the right side of the display
area.
Minimized View
A combination speedometer and
tachometer will show in the center of the
Minimized View.
Speedometer and Tachometer
Vehicle and engine speed are presented at
the center of the display. Units for vehicle
speed can be changed to either Standard
or Metric in the Digital Display menu (see
Units and Language on page 72) or by
using the steering wheel Shortcut button
(see )(see Peterbilt Digital Display Controls
on page 62).
Minimized View with Driver
Assistance (Option)
CONTROLS - Selecting a View
66 Y53-6126-1A1 (01/21)
3