operators_manual

Table Of Contents
5. Visually inspect the filter housing,
enclosure, and hardware for
damage.
If damaged, replace the air cleaner.
6. Gently, pull filter directly out of the
filter housing, taking care to not
drop or tap filter on housing during
removal.
Loose dirt and dust trapped in the
filter can fall into the cleaner, which
can lead to engine damage.
7. Inspect, and if necessary (and
using ONLY a clean, damp cloth)
clean out any debris inside the filter
housing. Be careful to not push any
contaminate into the engine inlet.
8. Visually inspect the new filter prior
to installation. There should not be
any damage to the filter media or
gaskets, such as dents, dings,
cracks, or holes.
9. Install new filter element, then
inspect element for a good seal
and proper alignment.
10. Install the filter housing cap and
tighten the bolts to 30 ± 5 in-lb. DO
NOT use the housing cap to drive
the filter into position.
11. Reconnect hose to filter housing
cap if removed earlier in this
procedure.
12. Verify housing cap is secure.
Close and secure hood.
Remove and Install Solenoid on Air
Filter Housing
These instructions are for removing and
installing the under hood air intake
solenoid from an air filter housing for
vehicles with the firewall mounted air
cleaner and optional under hood air intake
switch on the dash. This solenoid must be
removed to access the air filter.
With the under hood air intake option, there
is an additional step required to disconnect
the air line attached to the air filter housing
to access the air filter.
WARNING
Drain the air tank to depressurize the
air system before disconnecting any
air hoses. Failure to perform this step
may result in personal injury.
CAUTION
Ensure no foreign debris enters in sol-
enoid/airline. Failure to comply may re-
sult in equipment damage.
1. Park the vehicle, set the parking
brake, and turn the ignition OFF.
2. Open the hood.
3. Drain front air service tank of all air
pressure.
4. Disconnect the air line at the
connection on the air filter housing.
5. Push in on the collar and then pull
the air hose out.
WARNING
DO NOT disconnect any lines at the
solenoid body. They could be pressur-
ized which may result in personal in-
jury.
MAINTENANCE - Engine Maintenance
Y53-6126-1A1 (01/21) 269
5