operators_manual

Table Of Contents
Every 120,000 mi / 192,000 km / Annually
13
Drive Axle (Dana) - Air Shift Unit
Remove the housing cover and drain the lubricant. Wash the parts thoroughly and dry in air. (Refer to Drive Axle - Dana on
page 285 for maintenance instructions.)
Drive Axle (Dana) - Breather
Clean or replace. (Refer to Drive Axle - Dana on page 285 for maintenance instructions.)
Drive Axle (Dana) - Lube Pump (ON HIGHWAY)
Remove the magnetic strainer and inspect for wear particles. Wash in solvent and dry in air. (Refer to Drive Axle - Dana on
page 285 for maintenance instructions.)
Drive Axle (Dana) - Lube Filter (ON HIGHWAY)
Change. (Refer to Drive Axle - Dana on page 285 for maintenance instructions.)
Drive Axle (Dana) - Magnetic Drain Plug and Breather (ON HIGHWAY)
Clean or replace. (Refer to Drive Axle - Dana on page 285 for maintenance instructions.)
Drive Axle (Meritor Line Haul / ON HIGHWAY) - Lubricant Filter
Change the filter. (Refer to Drive Axle - Meritor on page 286 for maintenance instructions.)
Drive Axle (Meritor Line Haul / ON HIGHWAY) - Input Shaft and Pinion Shaft
Check and adjust the endplay. (Refer to Drive Axle - Meritor on page 286 for maintenance instructions.)
Drive Axle (Meritor Line Haul / ON HIGHWAY) - Axle Shaft
Tighten the rear axle flange nuts to the specified torque value. (Refer to Drive Axle - Meritor on page 286 for maintenance
instructions.)
13
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
those listed here.
MAINTENANCE - Every 120,000 mi / 192,000 km / Annually
224 Y53-6126-1A1 (01/21)
5