operators_manual

Table Of Contents
Every 60,000 mi / 96,000 km / 6 Months
12
Front Suspension U-bolts - U-bolts (ON HIGHWAY and VOCATIONAL)
Check the general condition and the tightness of the nuts. Tighten the U-bolts using a calibrated torque wrench to the specified
torque value. (Refer to Suspension U-Bolts, Grade 8 on page 306 for maintenance instructions.)
Front Suspension - SOFTEK
®
NXT (Hendrickson) - Ride Height
Inspect that ride height is within specifications. (Refer to Air Suspension Ride Height for maintenance instructions)
Drive Axle - Linehaul (PACCAR) - Axle Assembly
Drain and replace MINERAL BASE lubricant.
Drive Axle (Dana) - Axle Housing
Visually inspect for damage or leaks. (Refer to Drive Axle - Dana on page 285 for maintenance instructions.)
Check oil level. Check "cold." Torque the drain plug. (Refer to Drive Axle - Dana on page 285 for maintenance instructions.)
Drive Axle (Dana) - Air Shift Unit
Check the lubricant level. (Refer to Drive Axle - Dana on page 285 for maintenance instructions.)
Drive Axle (Dana) - Lube Pump (OFF HIGHWAY)
Remove the magnetic strainer and inspect for wear particles. Wash in solvent and dry in air. (Refer to Drive Axle - Dana on
page 285 for maintenance instructions.)
Drive Axle (Dana) - Lube Filter (OFF HIGHWAY)
Change. (Refer to Drive Axle - Dana on page 285 for maintenance instructions.)
Drive Axle (Dana) - Magnetic Drain Plug and Breather (OFF HIGHWAY)
Clean or replace. (Refer to Drive Axle - Dana on page 285 for maintenance instructions.)
12
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
those listed here.
MAINTENANCE - Every 60,000 mi / 96,000 km / 6 Months
Y53-6126-1A1 (01/21) 215
5