operators_manual

Component Specific Intervals
9
Clutch - Clutch Hydraulic Fluid
• Replace fluid and bleed system. 240,000 mi (384,000 km) or 2 years, whichever occurs first. (Refer to Hydraulic Clutch on page
298 for maintenance instructions.)
Tires and Wheels - Tires
• Check inflation pressure. Weekly "cold" using calibrated gauge. (Refer to Tires on page 290 for maintenance instructions.)
Driveshafts - Models SPL-90, 1710 and 1810 slip member and U-joints
• Inspect. U-joint inspections should be performed every time a vehicle comes in for scheduled maintenance.
Driveshafts - Models SPL-100 slip member and U-joints
• Inspect. U-joint inspections should be performed every time a vehicle comes in for scheduled maintenance.
Driveshafts - Models SPL-140/140HD/170/170HD/250/250HD slip members and U-joints (ON HIGHWAY and LINEHAUL)
• Inspect. U-joint inspections should be performed every time a vehicle comes in for scheduled maintenance.
Driveshafts - Models SPL-140/140HD/170/170HD/250/250HD slip members and U-joints (ON HIGHWAY and LINEHAUL)
• Inspect. U-joint inspections should be performed every time a vehicle comes in for scheduled maintenance.
Driveshafts - Models SPL-140XL/170XL/250XL slip members and U-joints (OFF HIGHWAY)
• Lubricate. 350,000 mi (560,000 km) 1st interval and then every 100,000 mi (160,00 km) after that.
Driveshafts - Models SPL-140XL/170XL/250XL slip members and U-joints (ON HIGHWAY and LINE HAUL)
• Inspect. U-joint inspections should be performed every time a vehicle comes in for scheduled maintenance.
9
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
those listed here.
*
Use only Spicer Driveshaft approved lubricants when greasing Spicer U-joints.
MAINTENANCE - Component Specific Intervals
Y53-6126-1A1 (01/21) 201
5