operators_manual

3. Press the "SET +" button to set the
cruise speed.
NOTE
Cruise Control may not hold the set
speed going down hills. If the speed
increases going down a hill, use the
brakes to slow down. This will cancel
Cruise Control.
The cruise set speed will appear in
the display.
How to Change Cruise Set Speed
The vehicle cruise control must be ON and
the cruise speed engaged.
1. To increase vehicle speed
• Press or long press SET + until
you reach the desired speed, or
• Use the Accelerator Pedal to
reach the desired speed, and
then press the Set +
2. To decrease vehicle speed, press
or long press RES – until you
achieve the desired speed, and
then press SET +.
The new cruise speed can be seen next to
the Cruise Control Indicator.
Canceling and Resuming Cruise
Control
There are four ways to cancel the set
speed in cruise control:
1. Tap the brake pedal
2. Tap the clutch pedal
3. Turn the cruise control system OFF
(ON/OFF button on steering wheel)
4. Press the Variable Road Speed
Limit buttons
Using the brake or clutch pedal to cancel
set speed allows the operator to use the
RESUME feature. Pressing the "- RES"
button will resume the vehicle speed
previously set.
Pressing ON/OFF once will deactivate
cruise control, and pressing it twice will
turn off the system. When turning the
system OFF, the previous set speed is
removed from memory. The operator will
have to manually reset the vehicle's cruise
speed.
Variable Road Speed Limiter
(option)
The Variable Road Speed Limiter (VRSL)
prevents the vehicle from exceeding a
chosen vehicle speed limit. This limit is
selected by the operator and can be
changed while driving. VRSL uses various
braking methods to enforce the limit
including ignoring further input from the
accelerator pedal, but will only use engine
braking if available and enabled.
VRSL replaces the Cruise Control indicator
when active and will show the VRSL limit
to the right of the indicator. This limit is
shown in gray but turns white when
actively limiting vehicle speed. MX
engines, additionally, show "LIMITED" on
the speedometer.
When active, the VRSL speed limit can be
changed using the LIM+ and LIM- buttons
in the right, steering wheel switch pod. See
How to Set the Variable Road Speed
Limiter. Enabling VRSL will disable Cruise
Control.
VRSL can be canceled by
• A long press of the Cruise Control
ON/OFF.
• Stopping then parking the vehicle.
• Activating the PTO (option) (MX
engine only).
How to Set the Variable Road
Speed Limiter
The Variable Road Speed Limiter (VRSL)
cannot establish a limit while the parking
brake is set or the PTO is in operation. The
minimum VRSL setting is 25 mph (40 kph).
DRIVING - Driver Assistance
144 Y53-6126-1A1 (01/21)
4