operators_manual

NOTE
Continued pressing of the high beam
flash will not keep the high beams on.
How to Flash Marker and
Clearance Lights
A button on the end of the Signal T
urn
stalk will momentarily flash the marker and
clearance lights when pushed.
Operate the Windshield
W
ipers
This vehicle is equipped with a two speed,
intermittent windshield wiper system. The
windshield wiper system is integrated with
the exterior lights so that the low beam
headlights will turn on when the windshield
wipers turn on.
WARNING
Clean blades regularly with a damp
cloth
to remove road film and wax
buildup. DO NOT drive with worn or
dirty wiper blades. They can reduce
visibility, making driving hazardous
which may lead to an accident result-
ing in death or personal injury.
CAUTION
DO NOT use antifreeze or engine
coolant
in the windshield washer res-
ervoir, damage to seals and other
components will result.
To override this function, turn the
headlights on and then of
f again.
Permanently overriding this functionality is
attainable via the Settings Menu in the
instrument cluster display. Go to
Settings > Wiper Interlock and turn this
value to OFF.
Avoid running the wiper blades over a dry
windshield to prevent scratching the glass.
Spray on washer fluid first. A scratched
windshield will reduce visibility.
A seven-position rotary wiper switch
(located on the turn signal lever) operates
the windshield wipers and washer
. If you
need to use the windshield wipers:
1. Rotate the end of the turn signal
lever to change the wiper mode
from off to on.
2. Rotate the outer knob of the turn
stalk lever to adjust the wiper
speed.
• Four levels of intermittent
speeds
• Low wiper speed
• High wiper speed
How to Spray Windshield
Washer Fluid
This vehicle is equipped with a function to
wash the windshield and simultaneously
engage the wipers.
CONTROLS - How to Flash Marker and Clearance Lights
82 Y53-6096-1C1 (09/20)
3