operators_manual

when the suspension achieves standard
ride height. The vehicle automatically
returns to standard ride height when
vehicle speed exceeds 7 MPH when in the
dump suspension mode. When the vehicle
is traveling faster than 7 MPH, dump
suspension mode will not activate.
NOTE
Speed thresholds are approximate.
NOTE
If the ignition is turned “off” and the ve-
hicle
is left in either the dump or
dumpd mode, the vehicle will remain in
that mode until the ignition is turned
back “on” and the appropriate switch is
pressed.
Raising Rear Suspension
The Raise Suspension switch raises the
rear suspension about 2 inches above
standard ride height, giving increased
ground clearance during drop and hook
operation. The green rear suspension LED
begins flashing once the suspension starts
to raise. The LED continues to flash to
indicate the vehicle is not at standard ride
height.
T
o return to standard ride height, press and
hold the Raise Suspension switch for
approximately one second and then
release. The green LED stops flashing
when the suspension achieves standard
ride height. The vehicle automatically
returns to standard ride height when
vehicle speed exceeds 7 MPH when in the
raise suspension mode. When the vehicle
is traveling faster than 7 MPH, raise
suspension mode will not activate.
NOTE
Speed thresholds are approximate.
NOTE
If the ignition is turned “off” and the ve-
hicle
is left in either the dump or raised
mode, the vehicle will remain in that
mode until the ignition is turned back
“on” and the appropriate switch is
pressed.
How to Use the Turn
Signal
The lever-action turn signal/high beam
switch is located on the left side of the
steering column. The ignition key must be
turned to ON for the signal/switch to
operate.
NOTE
If the vehicle turn signals and turn sig-
nal
indicators in the dash gauge clus-
ter ever begin flashing at an accelerat-
ed rate (115 cycles per minute) when
the turn signal lever is in the OFF
(center) position, or when a Right/Left
turn has been selected, the problem
may be related to a failed turn signal
switch or turn signal module. In either
case, the problem is not a failed bulb.
Contact your nearest authorized deal-
er to have the problem corrected as
soon as possible.
1. Push the Signal stalk lever up to
engage the RIGHT turn signal and
down to engage the LEFT turn
signal.
CONTROLS - How to Use the Turn Signal
80 Y53-6096-1C1 (09/20)
3