operators_manual

Application Type
Brake Treadle Hinge and Roller Engine oil
Lock Cylinders Lock lubricant
Door Hinges Do not lubricate
Door Latches and Striker Plates Polyethylene grease stick
Door Weatherstrip Silicone lubricant
Hub-piloted Aluminum Wheels Coat the wheel pilot or hub pads with Freylube #3 lubricant (light
colored) or Chevron Zinc lube. Do not get lubricant on the face of
the wheel or the hub.
Manual Transmission Hydraulic Clutch DOT3 (Brake Fluid)
(1) Consult manufacturer or lubricant supplier for special details.
Frame Fastener Torque
Requirements
CAUTION
Incorrectly tightening the fasteners may
result in failure of the fastener or incor-
rect clamp loads. Fastener failure may
lead to frame failure. Failure to comply
may result in equipment or property
damage.
• Use a torque wrench for final
tightening of these fasteners.
Due to the coating on the
threads of these bolts, be aware
that if an impact gun is used to
tighten the fasteners, they may
over-torque and break.
•
When torquing, the nut must ro-
tate slightly before achieving the
torque value. If the nut does not
rotate, the fastener is over-tor-
qued and should be replaced.
• To achieve correct clamp loads,
the frame fasteners must be tor-
qued with the nut. The intended
clamp load may not be achieved
if the nut is held and torque is
applied to the bolt.
Where Nylon lock-nuts are
indicated in the following tables,
•
Use only ESNA Style Lock Nut,
with nylon insert.
MAINTENANCE - Specification Reference Charts
250 Y53-6096-1C1 (09/20)
5