operators_manual

Table Of Contents
Topping Up the Engine Oil
1. Top up with oil, if necessary, via the
filler opening. Use the correct
grade in the correct quantity
. For oil
replacement, please see engine
Operator’s Manual included with
this chassis.
2. After topping up, wait 1 minute and
check the oil level again.
3. Reinstall the oil fill cap and twist to
lock it in place.
Install Engine Belt
Y
ou can extend the reliability and service
life of your vehicle's drive belts with proper
attention to installation and maintenance.
Neglect could cause belt failure. The result
could be the loss of the electrical or air
system as well as possible engine damage
from overheating.
NOTE
See the engine manufacturer's opera-
tor's
manual for further information on
replacing engine drive belts.
The images below may not appear like the
configuration of the vehicle. The procedure
is still the same. Follow this procedure to
install an accessory drive belt:
1.
Route the new belt around the
pulleys, and then rotate the
automatic tensioner so that the
idler pulley swings toward the belt
routing. The following figure shows
an example of the rotation direction
to release the tensioner.
MAINTENANCE - Engine Maintenance
Y53-6096-1C1 (09/20) 217
5