operators_manual

3. Check the Komfort Latch for cracks
or possible damage and check for
proper operation.
4.
Check buckle and latch for proper
operation and to determine if latch
plate is worn, deformed, or
damaged.
5. Inspect the retractor web storage
device, which is mounted on the
floor of the vehicle, for damage.
The retractor is the heart of the
occupant restraint system and can
often be damaged if abused, even
unintentionally. Check operation to
ensure that it is not locked up and
that it spools out and retracts
webbing properly.
6. If tethers are used, be sure they
are properly attached to the seat
and, if adjustable, that they are
adjusted in accordance with
installation instructions. Tethers
must also be inspected for web
wear and proper tightness of
mounting hardware.
7. Mounting hardware should be
evaluated for corrosion, and for
tightness of bolts and nuts.
8. Check web in areas exposed to
ultraviolet rays from the sun. If the
color of the web in these areas is
gray to light brown, the physical
strength of the web may have
deteriorated due to exposure to the
sun's ultraviolet rays. Replace the
system.
Once the need for replacement of the seat
belt has been determined, be certain it is
only replaced with an authorized PACCAR
Parts replacement seat belt. If the
inspection indicates that any part of the
seat belt system requires replacement, the
entire system must be replaced. An
installation guide is attached to every
replacement belt. Utilize the proper guide
for your type of seat, and follow the
instructions very closely. It is vitally
important that all components be
reinstalled in the same position as the
original components that were removed
and that the fasteners be torqued to
specification. This will maintain the design
integrity of the mounting points for the seat
belt assembly. Contact your dealer if you
have any questions concerning seat belt
replacement.
Windshield Wiper/Washer
The windshield wiper system is designed
to be maintenance-free. Check wiper
blades annually, every 60,000 miles
(96,000 km), or when they begin to show
signs of wear.
CAUTION
DO NOT use antifreeze or engine
coolant
in the windshield washer res-
ervoir, damage to seals and other
components will result.
Washer Reservoir
Daily: Check reservoir water level, located
in the engine compartment. If necessary,
refill to the proper level.
How to Refill the Washer Fluid
Reservoir
1. Park the vehicle and apply the
parking brakes
2. Open the hood and secure it in the
open position
3. Locate the washer fluid reservoir
and open the filler cap. It will be
located in one of two places:
1. Passenger side (RH) in front of
the steer tire - 2.4 Gallons (9
Liters) capacity
MAINTENANCE - Windshield Wiper/Washer
Y53-6096-1C1 (09/20) 205
5