operators_manual

Table Of Contents
Every 60,000 mi / 96,000 km / 6 Months
18
Electrical and Lights - Alternator
Check operation and output. (Refer to Alternator on page 214
Check tightness of the pulley nut. (Refer to Install Engine Belt on page 217 for maintenance instructions.)
Check the tension of the drive belt. (Refer to Install Engine Belt on page 217 for maintenance instructions.)
Check tightness of the terminal hex nuts. (Refer to Install Engine Belt on page 217 for maintenance instructions.)
Electrical and Lights - Starter
Check torque on hex nuts. (Refer to Electrical System on page 206 for maintenance instructions.)
Electrical and Lights - ECM Connector
Check the tightness of the ECM connector. (Refer to Electrical System on page 206 for maintenance instructions.) for
maintenance instructions.)
Electrical and Lights - Wheel Sensors
Check for damaged sensors and connectors, and worn or frayed wires. (Refer to Electrical System on page 206 for
maintenance instructions.)
Electrical and Lights - Power Supply Harnesses (engine, Transmission, etc.)
Check for worn or damaged insulation, corroded terminals, frayed. Wash to remove excess grease. (Refer to Electrical System
on page 206 for maintenance instructions.)
For Cab Structure, Doors and Hoods - Hinges and Latch
Lubricate with silicone spray.
18
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
those listed here.
MAINTENANCE - Every 60,000 mi / 96,000 km / 6 Months
172 Y53-6096-1C1 (09/20)
5