operators_manual

6. Pump until the locking bar can be
positioned on the anchor mounted
below the right-hand cab support.
7. Place the control valve handle in
the “Lower” position and allow the
cab to settle down slightly on the
locking bar
.
The raised cab with lockbar in place should
appear like this when complete.
Lowering the Cab
1.
Place the control valve handle in
the "Raise" position and pump until
the locking bar can be removed
from the anchor and fastened in its
stored position.
CAUTION
DO NOT try to pump the cab down or
hold
it down with hydraulic force. If you
do, cab damage will occur.
2. Place the control valve handle in
the "Lower" position. The cab
SAFETY - Cab Tilting
16 Y53-6096-1C1 (09/20)
1