operators_manual

where discrepancies develop between
these recommendations in this table and
component supplier recommendations.
•
Engine lubricating oil change
intervals aren’t listed here. Refer to
your engine’s operating manual for
recommendations. For specific
information on maintenance
procedures consult your vehicle
maintenance manual.
• The initial fill of drive axle lubricant
must be changed before the end of
the first scheduled maintenance
interval. See the axle
manufacturer's operator's manual
for recommended lubrication
specifications and service intervals.
• The initial fill of lubricant in manual
transmissions must be changed
before the end of the first
maintenance interval. See the
transmission manufacturer's
operator's manual for
recommended lubrication
specifications and service intervals.
• If your vehicle is equipped with an
automatic transmission, consult the
owner’s manual for it that came
with your vehicle to obtain lubricant
check and change intervals.
At first 15,000 mi / 24,000
km or at first PM
At first 15,000 mi / 24,000 km or at first PM
13
Front Suspension U-bolts
•
(ON HIGHWAY) Check the general condition and the tightness of the nuts. Tighten the nuts to the specified torque value as
required; (Refer to Suspension U-Bolts, Grade 8 on page 251 for maintenance instructions.)
• (VOCATIONAL) Check the general condition and the tightness of the nuts. Tighten the U- bolts after the first day or two of
operation. Then tighten the nuts to the specified torque value as required;(Refer to Suspension U-Bolts, Grade 8 on page 251
for maintenance instructions.)
Drive Axle (SISU) - Axle Housing
• Drive Axle (SISU) Oil Servicing on page 236
• Drive Axle (SISU) Inspection on page 236
• Drive Axle (SISU) Inspection on page 236
13
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
MAINTENANCE - At first 15,000 mi / 24,000 km or at first PM
those listed here.
Y53-6096-1C1 (09/20) 147
5