Instructions

VersiDrive i E3 User Guide Revision 1.03
6
www.peter-electronic.com
1 Quick Start Up
Quick Start – IP20 & IP66 Non Switched
Connect a Start / Stop switch between control terminals 1 & 2
5k – 10k
Close the Switch to Start
Open to Stop
Connect a potentiometer (5k – 10kΩ) between terminals as shown
to vary the speed from P-2 (0Hz default) to P-01 (50 / 60 Hz default)
0....10V
0.......50/60Hz
Quick Start – IP66 Switched
Switch the unit on using the isolator switch on the panel.
The OFF/REV/FWD will enable the output and control the direction
of rotation of the motor. The potentiometer will control the speed.
0.......50/60Hz