Instructions

VersiDrive i E3 User Guide Revision 1.03
www.peter-electronic.com
5
1 Quick Start Up
1.2. Quick Start Process
Step Action See Section Page
1 Identify the Enclosure Type, Model Type and ratings of
your drive from the model code on the label. In
particular
- Check the voltage rating suits the incoming
supply
- Check the output current capacity meets or
exceeds the full load current for the intended
motor
2.1 Identifying the Drive by Model Number 7
2 Unpack and check the drive. Notify the supplier and
shipper immediately of any damage.
3 Ensure correct ambient and environmental conditions
for the drive are met by the proposed mounting
location.
9.1 Environmental 26
4 Install the drive in a suitable cabinet (IP20 Units),
ensuring suitable cooling air is available. Mount the
drive to the wall or machine (IP66).
3.1
3.3
3.4
3.5
3.6
General
Mechanical Dimensions and Mounting – IP20 Open Units
Guidelines for Enclosure Mounting – IP20 Units
Mechanical Dimensions – IP66 (Nema 4X) Enclosed Units
Guidelines for mounting (IP66 Units)
8
8
8
9
5 Select the correct power and motor cables according
to local wiring regulations or code, noting the
maximum permissible sizes
9.2 Rating Tables 26
6 If the supply type is IT or corner grounded, disconnect
the EMC filter before connecting the supply.
4.2 EMC Filter Disconnect 11
7 Check the supply cable and motor cable for faults or
short circuits.
8 Route the cables
9 Check that the intended motor is suitable for use,
noting any precautions recommended by the supplier
or manufacturer.
10 Check the motor terminal box for correct Star or Delta
configuration where applicable
4.6 Motor Terminal Box Connections 12
11 Ensure suitable wiring protection is providing, by
installing a suitable circuit breaker or fuses in the
incoming supply line
9.2 Rating Tables 26
12 Connect the power cables, especially ensuring the
protective earth connection is made
4.1
4.3
4.4
Grounding the Drive
Wiring Precautions
Incoming Power Connection
11
11
12
13 Connect the control cables as required for the
application
4.8
4.9
7
Control Terminal Wiring
Connection Diagram
Analog and Digital Input Macro Configurations
13
13
22
14 Thoroughly check the installation and wiring
15 Commission the drive parameters 5.1
6
Managing the Keypad
Parameters
15
16